Votos - 2, Puntuación media: 4.5
(
)
)
|
Resumen del manual
• Side panels are required whenever the sides of the product are exposed. • Side panel sizes vary depending on the type of installation being made. To accomplish an attractive installation, you must: 1. Determine the need for side panels. 2. Determine side panel thickness. 3. Order matching side panels from the cabinet manufacturer. Be sure to provide the exact dimensions. Monogram built-in refrigerators and freezers can be installed flush with typical 24-3/4" deep cabinetry. When installed semi-flush, the case trim will conceal slight gaps around the enclosure. The refrigerator will project forward approximately 3/4" beyond the front face of surrounding cabinetry. For answers to your Monogram,® GE Profile™ or GE appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000. R Listed by Underwriters Laboratories Monogram.“ ZIFS36NM – GE Monogram 36" Built-In Stainless Steel All-Freezer Water Location3-1/2" 5" 6" 5" Electrical Outlet Location 2-1/2" 75" Electrical and Water Connection Locations The water line can be routed through the floor or back wall. • The icemaker water line should be: – Approximately 3-1/2" from the floor on the back wall, or 3-1/2" from the back wall on the floor. –At least 5" from either side of the opening. A 115 volt, 60 Hz. 15 or 20 amp power supply is recommended. An individual properly grounded branch circuit or circuit breaker is recommended, as noted on the rating plate. • Locate the electrical outlet within 5" x 7" shaded area shown. – 2-1/2" from the left side. Between 74" and 81" from the floor. Important: To insure a flush fit and access to the power cord, locate the electrical outlet as shown. 251Dia5925" Minimumto Wall130° Door Swing 36-3/4" 251Dia604" Min. to Wall90° Door Swing Clearances • Factory set for a 130° door swing. Order WX14X99 adjustable door stop to reduce swing to as little as 90°. When Installed into a corner: Allow 25" for a full 130° door swing. Allow 15" for pan removal. Allow 4" min. clearance when door swing is adjusted to a 90° opening for pan access, but pan removal is restricted. When installing an All-Refrigerator and All-Freezer side-by-side, allow 25" for a full 130° door swing, or 15" min. on the hinge sides for pan access. 90° door swing with optional WX14X99 door stop. 251Dia6125" Min. toWall0" 25" Min. toWall130° Door Swing130° Door Swing ZUGSS Unified Grille Panel Kit is available for side-by-side installations. See Trim Kit descriptions. Accessory Grille Panel Kits These models are factory set for 84" installation height. Adjustments to 83-1/2" or 84-1/2" heights can be made by changing the grille panel. Order ZGCSS36RH (right hand) or ZGCSS36LH (left hand) Grille Panel Kit. These kits include 2 grille panels, for 83-1/2" and 84-1/2" installation heights. ZUGSS Unified Grille Panel Kit For side by side installation, order ZUGSS Grille Panel Kit. This kit provides one continuous panel to span the width of two products installed togeth...
Otros modelos de este manual:Congeladores - MONOGRAM ZIFS36NM (190.07 kb)
Congeladores - MONOGRAM ZIFS36NM (190.07 kb)
Congeladores - MONOGRAM ZIFS36NM (190.07 kb)
Congeladores - MONOGRAM ZIFS36NM (190.07 kb)