Votos - 4, Puntuación media: 4.5
(
)
)
|
Resumen del manual
Insert less food. Insert food of room temperature only. Check if door is fully closed. Cooling is too strong. Thermostat is set too high. Set to lower position. No cooling at all. Plug is not properly inserted into socket. No current in socket. According to the indicator, the on/off switch (B) is not switched on. Check plug-socket connection. Check presence of current. Press the on/off switch (B) for more than a second. Noisy operation Product support is not correct. Check stability of product support (all four feet should stand on floor). A rectangular symbol is shown on the right side of display "D" Temperature sensor problem Call the service personnel In as much as the advice does not lead to result, call your nearest Service Force Centre Power or operation failure: In case of power failure during the storage of frozen foods, make sure not to open the freezer door. Once the power failure is over, the yellow indicator (3) of the quick freeze function will light up and then, 5 hours after restart, it will automatically go out. If a short power failure occurs (max. 13 hours) and the appliance is full, the stored foods will not deteriorate. Otherwise you must use the stored food as soon as possible (if the temperature of the frozen foods rises, their storability will be shorter). When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The product will continue to operate with the use of a reserve system until the problem is eliminated by the local service personnel. GB Instructions for the Installer Installing the appliance front two. 1-1 piece of distance washers (2) are accessories of the adjustable feet. When levelling the appliance if necessary , these washers can be removed. Transportation, unpacking It is recommended to deliver the appliance in its original packaging, in a vertical position. After each transportation the appliance must not be switched on for approx. 2 hours. Unpack the appliance and check if there are damages on it. Report possible damages immediately to the place of purchase. In which case retain packaging. Cleaning Remove any adhesive tape, which ensure the parts do not move in the appliance. Wash the inside of the appliance using lukewarm water and mild detergent. Use soft cloth. After cleaning wipe out the inside of the appliance. Placement The ambient temperature has an effect on the energy consumption and proper operation of the appliance. When placing, take into consideration that it is practical to operate the appliance between ambient temperature limits according to the climate class that is given in the chart below and can be found in the rating plate. Do not stand the appliance on a sunny place or close to a radiator or cooker. If it is unavoidable because of furnishing and the appliancehas to be stood near a cooker take these minimumdistances into consideration: Class of climate Ambient temperature SN +10 ... +32 °C N +16 ... +32 °C ST +18 ... + 38 °C If the ambient temperature goes below the lower data the temperature of the cooling compartment can go beyond the prescribed temperature. If the ambient temperature goes beyond the upper data this means longer operating time of the compressor, increasing temperature in the freezer or increasing energy consumption. When placing the appliance ensure that it stands level. This can be achieved by the two adjustable feet (1) bottom When placing the refrigerator keep minimal distances recommended in figure. A: placing it under a wall-cupboard B: placing it freely Change of door opening direction Should the setting-up place or handling demand it, door- opening direction can be refitted from the right hand side to the left hand side. Following operations are to be done on the basis of figures and explanations: Pull out the plug from the mains socket. Tilt back the appliance carefully so that the compressor can not touch the floor. It is recommended to ask another person for help, who can keep the appliance at this position safely. Unscrew the adjustable feet situated on both sides (2 pieces), in addition the screws fixing the lower door holders (2 pieces) respectively the screw on the other side. Take off the freezer door by pulling it slightly downwards. Unscrew the top door hinge pin of the refrigerator then screw it back on the other side. Fit the freezer door on the upper door hinge pin. Insert over the pin in the lower door holding plate in the direction of the arrow. Fix the plate on the other side leaving the position of the door unchanged. GB Then screw in the one screw in the place set free on the other side as well as the adjustable feet (2 pieces) and stand upright again. Place over the handles on the other side and put the plastic covering pins supplied in the plastic bag of this instruction book into the vacant holes. Place the appliance back into its location, set it level and plug it into the mains socket. In case you do not want to perform the procedures above, call y...