Votos - 0, Puntuación media: 4
(
)
)
|
Resumen del manual
Pinnacle tabletop lectern or Pinnacle Full Height lectern with 2 sided panel call 800-267-5486 2. electret gooseneck mic or 847-498-9000 3. sw225 voice Projector 4. wireless headset and lapel mic with transmitter email: customerservice@ 5. Power cord amPli.com 6. 25 Foot xlr cable 7. installed powerstrip 1. 3. 1. 2. 6. 7.5.4. Thank you for choosing the Wireless Pinnacle Lectern from AmpliVox Portable Sound Systems. Our system combines flexibility with functionality. Please refer to this user guide as you enjoy the unique capabilities of another quality product from AmpliVox Portable Sound Systems. As always, you can reach us at 800-267-5486, or at 847-489-9000, Monday - Friday 8am - 6pm CST. Made in USA user guiDe taBle oF contents/wHat’s in tHe Box?................. 1 Battery installation / set uP .................................. 2 control Panel layout................................................. 3 wireless mic setuP ...................................................... 3 ProBlem solving .......................................................... 4 Pinnacle 1 FEATURES: The Pinnacle comes with a Gooseneck Mic that installs on the cable mounted in the shock mount on the reading table. That cable is prewired to the bottom of the unit where you plug in the supplied XLR cable to the SW225. The light is powered by an AC power adapter that is plugged into an outlet strip mounted inside the unit on the bottom which has its plug mounted in the bottom side of the unit. You plug in the supplied power cord from the base of the unit to house AC. The clock/timer is battery operated (LR44 Watch Batteries, not included). The batteries can be replaced by pulling the clock out of the panel. The batteries are in the back of the timer. Power corD xlr caBle BATTERY INSTALLATIoN / SET-UP: install Power suPPly in all comPonenets: ImPoRTANT! Do not mix battery types or attempt to recharge alkaline batteries. Equipment dammage, safety hazard or fire could result. Remove batteries if the unit is not going to be used for long periods of time to prevent leakage. SW225 Wireless Voice Projector: Runs on AC power or battery power. The battery carriage holds 10 D-cell alkaline batteries or our S1465 NiCad battery pack (requires S1460 AC adapter to recharge). Or run on a 12 Volt DC adapter (automotive cigarette lighter plug-in, not included). Lapel & Headset Mic Battery Installation: Requires one 9-Volt battery or a 9-Volt AC adapter (not supplied). Remove battery door on back of transmitter. insert one new 9 volt alkaline battery, observing polarity, and replace the door. sw225 wireless mic set uP: The frequency appears on the back of each unit. Both transmitter and receiver must have the same, and both units must be set to either “A” or “B.” Note that two transmitters on the same frequency will not work with one receiver. However two or more receivers will work with the same transmitter. Before use, make certain you understand the function and operation of the system. Plug headset or lapel microphone into transmitter labled with 171, select A or B frequency, turn power switch ON. A red light should come on. Turn SW225 on with the main power switch. When the power switch is in the ON position, the red light will be on. Turn wireless receiver power switch on and select matching frequency to the mic transmitter, either A or B. Both the microphone transmitter and the amplifier have to be on the same frequency for the wireless mic to work proplerly. If you CLOCK/TIMER LED LAMP PADDED ARM REST & PAPER STOP ELECTRET gOOSENECK MIC 9V DC ALKALINE BATTERY RIBBON FOR BATTERY REMOVAL BATTERY COVER transmitter Battery installation encounter interference, switch frequencies. Rotate VOLUME control knob on the amplifier to obtain desired loudness level throughout the coverage area. The microphone has an ON/OFF switch. it should always be in the OFF position until the main power is ON and you are ready to speak. The VHF wireless microphone system is compact, lightweight and compatible with all AmpliVox VHF wireless systems. The wireless mic operates in an authorized VHF band and has a useful range of up to 200-ft. in line-of-sight applications. Each system operates on two crystal-controlled, switch selectable frequencies for clear clean transmission. “A” Channel “B” Channel T6: 171.105 MHz T7: 171.845 Pinnacle 2 CoNTRoL PANEL: sw225 voice Projector HANDLE AMPLIFIER CONTROL PANEL BATTERY DOOR PANEL MAIN POWER SWITCH The MAIN POWER switch is located on the control panel. Flip the rocker switch to the ON position. The red light next to the switch will light up showing that the power is on. DC INPUT Connection for an optional external power adapter. AUX OUT Power source for 12 to 15V DC accessories. MASTER VOLUME Controls the volume level of the microphones, including the wireless microphones. MICROPHONE INPUTS There are three microphone inputs, which can be used simultaneously: DYNAMIC - for standard dynamic microphones, 1/4 in. CONDENSER -for electr...
Otros modelos de este manual:estéreo - ST3250 (277.74 kb)