Votos - 6, Puntuación media: 4.2
(
)
)
|
Resumen del manual
Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound. Direct the loudspeakers towards the listening area. For optimum performance, make sure that both speakers are placed at an equal distance above the floor. Where to Install Your Mini-Compact System Connecting your System to the Power Supply GB 6 Insert or replace remote control batteries when you: Purchase the mini-compact system Find that the remote control is no longer operating correctly When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries. Place your thumb on the position marked on the battery compartment cover (rear of the remote control) and push the cover in the direction of the arrow. Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities: + on the battery against + in the battery compartment – on the battery against – in the battery compartment Replace the cover by sliding it back until it clicks into position. If you will not be using the remote control for a long time, remove the batteries to prevent corrosion. Inserting Remote Control Batteries 1 2 3 COUNT RESET The auxiliary input can be used to take advantage of the sound quality of your mini-compact system when listening to other sources. Examples: A television A video disc player A Hi-Fi stereo video cassette recorder To connect to the external source, the source must have an audio output. In addition, you need an RCA connection cable. Set the system to standby mode and disconnect it and the external source from the main socket. Connect the audio cable to the rear of the mini-compact system. Connect the... To the connector marked... Red jack R (right) White jack L (left) For optimum sound quality, do not invert the right and left channels. Plug the system back into the main socket and press STANDBY/ON to switch it on. Select the AUX source by pressing AUX. Result: AUX is displayed. Switch the external source on. Adjust the volume and balance as required: Volume Equalizer Example: You can watch a film and take advantage of stereo sound provided that the original sound track is in stereo (as if you were in a cinema). Connecting to an External Source 1 2 3 4 5 6 The main lead must be plugged into an appropriate socket. Before plugging your system into a main socket, you must check the voltage. Plug the main lead (AC cord on the rear of the system) into an appropriate socket. Press the STANDBY/ON button to switch your mini-compact system on. 1 2 4 3 The loudspeaker connector terminals are located on the rear of the system. There are four terminals on the system: Two for the left speaker (marked L) Two for the right speaker (marked R) To achieve the correct sound quality, connect the: Red wire to the + terminals Black wire to the – terminals Press and hold the terminal tab. Insert the speaker cord. Release the finger. 1 2 3 L R Connecting the Loudspeakers The AM aerial (for long and medium waves) can be: Placed on a stable surface Fixed to the wall (you must first remove the base) The AM aerial connector terminals are located on the rear of the system and are marked AM . To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires. Always keep them at least 2 inches (5 cm) away. Connecting the AM (MW) Aerial How to connect a COAXIAL TYPE aerial. Connect a 75. antenna to the FM antenna terminal. Plug the connector on the FM aerial supplied into the coaxial socket (75.) marked FM on the rear of the system. Follow the instructions given on Page 14 to tune into a radio station, and determine the best position for the aerial. If reception is poor, you may need to install an outdoor aerial. To do so, connect an outdoor FM aerial to the FM socket on the rear of the system using a 75. coaxial cable (not supplied). Connecting the FM Aerial The CD disc changer can contain up to three 12 cm or 8 cm compact discs without using an adapter. Never force the compact disc carrousel when opening and closing the compartment. Never press down or place objects on the carrousel. Always treat your compact discs with care; refer, if necessary, to the section entitled “Precautions When Using Compact Discs” on page 24 . Switch the system on by pressing STANDBY/ON. Press the OPEN/CLOSE( ) button on the front panel. Result: The compartment opens. Place one disc in the front slots of the carrousel, with the label on the discs facing upwards. Check that the compact disc has been correctly inserted in the holder before closing the compartment. If you wish to load another disc, press the DISC CHANGE button on the front panel (or DISC SKIP on the remote control). Result: The carrousel rotates by 120°. Close the compartment by pressing the OPEN/CLOSE( ) button again. If you wish to start playing a disc directly, you can also proceed as follows. To play... Press... Disc 1 CD/MP3-CD ( ) or Disc 1 Disc 2 Disc 2 Disc 3 Disc 3 Result: The compartment closes automati...
Otros modelos de este manual:estéreo - MAX-C570 (6.42 mb)