Votos - 2, Puntuación media: 3.5
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Connecting to a TV Method 1 Using Video Out (Cable Included) Method 2 Using S-Video Out (Cable Not Included) Connect Video Out on the player to Video In on your TV. 1 Connect S-Video Out to S-Video In on your TV. 1 • Composite Video: A single video signal that is a composite of the black-and-white information (Y) and the color information (C). • S-Video: A video transmission standard that provides a sharper, brighter picture than ordinary composite video by separating brightness and color signals. Note CONNECTIONS Press the TV/VIDEO button on the remote of TV control to set the TV to "VIDEO". 2 Press the TV/VIDEO button on the remote control of TV to set the TV to "S-VIDEO". 2 11 Connect Audio In on the DVD player to Audio Out on the external analog component. • Be sure to match connector colors. 1 Example: Analog signal components such as a VCR, Camcorder, and TV. Connecting to an External Analog Component Connecting to External Components R L Audio Cable If the external analog component has only one Audio Out, connect either left or right. Press AUX to select AUX. • ‘AUX’ appears in the display. 2 12 CONNECTIONS Connecting the FM and AM(MW/LW) Antennas FM antenna connection AM(MW/LW) antenna connection 1. Connect the FM antenna supplied to the FM 75. COAXIAL terminal as a temporary measure. 2. Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface. • If reception is poor, connect an outdoor antenna. Before attaching a 75. coaxial cable (with a standard type connector), disconnect the supplied FM antenna. 1. Connect the AM loop antenna supplied to the AM and terminals. 2. If reception is poor, connect an outdoor single vinyl-covered wire to the AM terminal. (Keep the AM loop antenna connected). Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna. If FM reception is poor, connect an outdoor FM antenna (not supplied). FM Antenna (supplied) AM Loop Antenna (supplied) If AM reception is poor, connect an outdoor AM antenna(not supplied). Setting the Clock For each step, you have a few seconds to set the required options. If you exceed this time, you must start again. Setting the Clock For each step, you have a few seconds to set the required options. If you exceed this time, you must start again. 1 1 Switch the system on by pressing POWER button. When the correct 4 hour is displayed, press ENTER. The minutes flash. • Increase the minutes : • Decrease the minutes : 2 Press TIMER/CLOCK twice. • CLOCK is displayed. 5 5 When the correct time is displayed, press ENTER. •"TIMER" appears in the display. • The current time is now set. 3 Press ENTER. The hour flashes. • Increase the hours : • Decrease the hours : Note • You can display the time, even when you are using another function, by pressing TIMER/CLOCK once. Selecting the Video Format Turn off the main unit and then press NTSC/PAL. • By default, the video format is set to "PAL". • Each time the button is pressed, the video format switches between "NTSC" and "PAL". • Each country has a different video format standard. • For normal playback, the video format of the disc must be the same as the video format of your TV. Checking the Remaining Time Press the REMAIN button. • For checking the total and remaining time of a title or chapter being played. Each time the REMAIN button is pressed 13 CHAPTER REMAIN TITLE REMAIN CHAPTER ELAPSED TITLE ELAPSED TRACK REMAIN TOTAL ELAPSED TOTAL REMAIN TRACK ELAPSED DVD CD VCD Disc Playback 2 Load a disc. • Place a disc gently into the tray with the disc’s label facing up. • Depending on the content of the disc, the initial screen may appear different. • Depending on the recording mode, some MP3-CDs cannot be played. • Table of contents of a MP3-CD varies depending on the MP3 track format recorded on the disc. 1 Press OPEN/CLOSE button to open the disc tray. 3 Press OPEN/CLOSE button to close the disc tray. DVD VCD CD • Playback starts automatically. DivXMP3 JPEG • Playback starts automatically. • If the TV is on, a list of MP3s on the CD will appear on the TV screen. Something like you Back for good Love of my life More than words I need you My love Uptown girl DVD RECEIVER SMART NAVI Note CONNECTIONS To stop playback, To temporarily pause playback, press STOP during playback. press PLAY/PAUSE during playback. • If pressed once, “PRESS PLAY” is displayed and the • To resume playback, press PLAY/PAUSE stop position will be stored in memory. If PLAY/PAUSE button again. ( ) button or ENTER button is pressed, playback resumes from the stop position. (This function works only with DVDs.) • If pressed twice, “STOP” is displayed, and if PLAY/PAUSE ( 14 ) button is pressed, playback starts from the beginning. DivX Playback Skip Forward/Back During playback, press the button. • Go to the next file whenever you press button, if there are over 2 files in the disk. • Go to the previous file whenever you press button, if there are ...
Otros modelos de este manual:estéreo - MM-DJ8 (9.04 mb)