Votos - 3, Puntuación media: 4
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
To select recording bit rate and speed 1. Press REC. on the unit or XREC on the remote control for longer than 3 seconds on the state of stop. 2. Use C/V on the remote control or / on the unit to select the bit rate. 3. Press REC. on the unit or XREC on the remote control again to select the recording speed. 4. Press C/V on the remote control or / on the unit to select a desired recording speed; (Only AUDIO CD) X1 SPEED -You can listen to music while recording it. X2 SPEED -You can just record the music file. 5. Press REC. on the unit or XREC on the remote control to finish the setting. Operating 17 yWhen you stop recording during playback, the file that has been recorded at that time will be stored. yDo not remove the USB device or turn off the unit during USB recording. If not, an incomplete file may be made and not deleted on PC. yIf USB recording does not work, the message like “NO USB”, “ERROR”, “FULL” or “NO REC” is displayed on the display window. yMulti card reader device or External HDD can not be used for USB recording. yA file is recorded by about 512 Mbyte when you record for a long term. yYou may not store more than 999 files. yIt’ll be stored as follows. AUDIO CD The other source* * : TUNER, Portable and the like. , Note The making of unauthorized copies of copy- protected material, including computer programs, files, broadcasts and sound recordings, may be an infringement of copyrights and constitute a criminal offense. This equipment should not be used for such purposes. Be responsible Respect copyrights 3 Operating 18 Troubleshooting Troubleshooting 4 Troubleshooting Problem Cause & Correction No Power. • The power cord is not plugged in. Plug in the power cord. • Check whether electricity failed. Check the condition by operating other electronic devices. No sound. • Check whether you select right function. Press FUNCTION and check the selected function. • If not, connect speaker cables correctly. Speaker cables connected correctly. The unit does not start playback. • An unplayable disc is inserted. Insert a playable disc. • No disc is inserted. Insert a disc. • The disc is dirty. Clean the disc. (Refer to the 20 page) • The disc is inserted upside down. Place the disc with the label or printed side facing upwards. Radio stations cannot be tuned in properly. • The antenna is positioned or connected poorly. Connect the antenna securely. • The signal strength of the radio station is too weak. Tune to the station manually. • No stations have been preset or preset stations have been cleared (when tuning by scanning preset channels). Preset some radio stations, see page 12 for details. The remote control does not work properly. • The remote control is too far from the unit. Operate the remote control within about 23 ft (7 m). • There is an obstacle in the path of the remote control and the unit. Remove the obstacle. • The batteries in the remote control are exhausted. Replace the batteries with new ones. iPod does not work. • Check whether the player is connected to the unit correctly. Connect it to the unit correctly. Appendix 19 Specifications General Power requirements Refer to the main label Power consumption Refer to the main label Dimensions (W x H x D) 230 X 134 X 228 mm Net Weight (Approx.) 1.9 kg Operating temperature 0 °C to 40 °C Operating humidity 5 % to 90 % Bus Power Supply USB DC 5 V 0500 mA iPod DC 5 V 01 A Inputs/ Outputs PORT. IN 0.6 Vrms 5 Tuner FM Tuning Range 87.5 MHz to 108 MHz Amplifier Stereo mode 70 W + 70 W CD Frequency Response 20 Hz to 20 KHz Signal-to-noise ratio 75 dB Dynamic range 80 dB Appendix Front Speaker Type 2 way 2 speaker Impedance Rated 8 . Input Power 70 W Max. Input Power 140 W Net Dimensions (W x H x D) 144 X 268 X 191 mm Net Weight 1.86 kg • Design and specifications are subject to change without notice. 20 Appendix 5 Appendix Maintenance Handling the Unit When shipping the unit Please save the original shipping carton and packing materials. If you need to ship the unit, for maximum protection, re-pack the unit as it was originally packed at the factory. Keeping the exterior surfaces clean Do not use volatile liquids such as insecticide spray near the unit. Wiping with strong pressure may damage the surface. Do not leave rubber or plastic products in contact with the unit for a long period of time. Cleaning the unit To clean the player, use a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth lightly moistened with a mild detergent solution. Do not use strong solvents such as alcohol, benzine, or thinner, as these might damage the surface of the unit. Maintaining the Unit The unit is a high-tech, precision device. If the optical pick-up lens and disc drive parts are dirty or worn, the picture quality could be diminished. For details, please contact your nearest authorized service center. Notes on Discs Handling Discs Never stick paper or tape on the disc. Storing Discs After playing, store the disc in its case. Do not expose the dis...