Votos - 6, Puntuación media: 4.7 ( )

Fabricar: Kenwood Tamaño del archivo: 1.26 mb Nombre del archivo: Idioma del manual:

3. Item 17 complies with UL in the U.S.A. 7Handling of discs and tapes 7Handling of discs and tapes XD SERIES (En) Disc handling precautions Label side Cleaning If fingerprints or foreign matter become Handling attached to the disc, lightly wipe the Hold compact discs so that you do not disc with a soft cotton cloth (or similar) touch the playing surface. from the center of the disc outwards, in a radial manner. Playing ODo not attach paper or tape to either side the playing side or the label side of Sticker compact discs. Storage OThe paste left on the label surface after a sticker has been peeled off is a factor When a disc is not to be played for a which may cause malfunction. If the long period of time, remove it from the surface is sticky due to remaining paste, CD player and store it in its case. be sure to clean it with alcohole before Sticky paste use. Caution on disc used Never play a cracked or warped disc. During playback, the disc rotates at high speed in the player. Therefore, to avoid danger, never use a cracked or deformed disc or a disc repaired with tape or adhesive agent. Do not use cleaning discs. Please do not use commercially available cleaning discs, they may dam- Preparation age the internal mechanism. CD (12 cm, 8 cm) Discs which can be played with this unit OWith CD-G (CD Graphics) discs, this unit can play only the audio. When there is slack in the tape In such a case, insert a pencil into the reel hole and wind the reel hub to remove the slack. Notes on cassette tape Safety tab (accidental erasure prevention tab) After an important recording has been finished, break the safety tab, to prevent the recorded contents from being erased or recorded on accidentally. To store cassette tapes Do not store the tapes in a place which is subject to direct sunlight, or near equipment that generates heat. Keep the cassette tapes away from any magnetic field. To re-record Apply tape only to the position where the tab has been removed. 1. Longer tape than 110 minutes cassette tape Since longer tape than 110 minutes cassette tape is very thin, the tape could adhere to the pinch roller or be easily cut. It is recommended that these tapes not be used with this unit to prevent possible damage. 2. Endless tapes Do not use an endless tape, as this could damage the mechanism of the unit. N S For B side For A side NoteNoteNote 8 system connection 8 system connection XD SERIES (En) 1 2 3 Caution regarding placement To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below. Rear panel: 10 cm AM loop antenna connection Preparation ANTENNA AM loop antenna connection FM 75 W AM The supplied antenna is for indoor use. Place it as far as possible from the main system, TV set, speaker cords and power cord, and set it to a direction which provides the best reception. GND FM 75 W AM ANTENNA GND AUX INPUT – + – SPEAKERS (6–16 W ) SUPER WOOFER PRE OUT R FM 75 W AM ANTENNA GND AC 220 –240V AC 110 –120V R + FM antenna connection FM indoor antenna connection The accessory antenna is for temporary indoor use only. For stable signal reception we recommend using an outdoor antenna. Remove the indoor antenna if you 1 Strip the coating from the tip of cord and twist the conductor. (Except for Europe and U.K.) 2 Connect to the antenna terminal. 3 Locate the position providing good reception condition. connect one outdoors. FM outdoor antenna Lead the 75W coaxial cable connected to the FM outdoor antenna into the room and connect it to the FM 75W termimal. R AUX INPUT R – + + – SPEAKERS W ) FM 75 W AM ANTENNA GND AC 220 –240V AC 110–120V R AUX INPUT R – + + – SPEAKERS W ) FM 75 W AM ANTENNA GND AC 220 –240V AC 110–120V FM 75 W AM ANTENNA GND FM 75 W AM ANTENNA GND FM 75 W AM ANTENNA GND FM 75 W AM ANTENNA GND 10mm 10mm 4 Fix the antenna. Antenna adapter (optional) 9system connection 9system connection XD SERIES (En) Do not plug the power cord into the power outlet until all of the required connections have been made. Connection of the speaker system ANTENNA FM 75 W AM GND AC 110 –120V AC 220 –240V R L AUX INPUT PreparationR L – + + – SPEAKERS (6–16 W ) R L – + + – Speaker front view (the front net can not be removed) Connect only provided main unit. • Never short-circuit the + and – speaker cords. • If the left and right speakers are connected inversely or if the speaker cords are connected with reversed polarity, the sound becomes unnatural with ambiguous acoustic image positioning. Be sure to con- nect the speakers and speaker cords NoteNoteNote correctly. Connection of options (Optional parts) Connect separately sold parts as shown in the figure. Do not plug the power cord into the power outlet until all of the required connections have been made. SUPER WOOFER Only XD-A31/XD-302 MD PLAYER Audio output R L AUX INPUT R L – + + – SPEAKERS (6–16 W ) FM 75 W AM ANTENNA GNDR L AUX INPUT SUPER WOOFER PRE OUT SUPER WOOFE...

Descargar ahora

Introduzca dos números de la imagen: