Votos - 2, Puntuación media: 4
(
)
)
|
Fotos y especificaciones Sony CMT-SPZ70 |
Resumen del manual
When unplugging the unit, always grip the plug. Never pull the cord itself. • Should any solid object or liquid get into the system, unplug the system, and have it checked by qualified personnel before operating it again. • The AC power cord can be changed only by a qualified service facility. On placement • Do not place the system in an inclined position or in locations that are extremely hot, cold, dusty, dirty, or humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light. • Be careful when placing the unit or speakers on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result. • If the system is brought directly from a cold to a warm location or is placed in a very damp room, moisture may condense on the lens inside the CD player, and cause the system to malfunction. In this situation, remove the disc, and leave the system turned on for about a few hours until the moisture evaporates. On heat buildup • Heat buildup on the unit during operation is normal and is not cause for alarm. • Do not touch the cabinet if it has been used continuously at a high volume because the cabinet may have become hot. • Do not obstruct the ventilation holes. On the speaker system This speaker system is not magnetically shielded, and the picture on nearby TV sets may become magnetically distorted. In this situation, turn off the TV, wait 15 to 30 minutes, and turn it back on. If there is no improvement, move the speakers far away from the TV. Cleaning the cabinet Clean this system with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as thinner, benzine, or alcohol. To prevent a tape from being accidentally recorded over Break off the cassette’s overwrite protection tab from side A or B as illustrated. Break off the cassette tab To later reuse the tape for recording, cover the broken tab with adhesive tape. About a tape longer than 90 minutes The use of the tape with more than 90 minutes of play time is not recommended except for long, continuous recording or playback. Cleaning the tape heads Use dry- or wet-type cleaning cassette (available separately) after every 10 hours of use, before you start an important recording, or after playing an old tape. Failure to clean the tape heads can cause degraded sound quality or an inability of the unit to record or play tapes. For details, refer to the instructions of the cleaning cassette. Demagnetizing the tape heads Use a demagnetizing cassette (available separately) after every 20 to 30 hours of use. Failure to demagnetize the tape heads can cause an increase in noise, a loss of high frequency sound, and an inability to completely erase tapes. For details, refer to the instructions of the demagnetizing cassette. Specifications Amplifier section CMT-SPZ70 European and Russian models: DIN power output (rated): 60 + 60 W (4 ohms at 1 kHz, DIN) Continuous RMS power output (reference): 75 + 75 W (4 ohms at 1 kHz, 10% THD) Music power output (reference): 75 + 75 W (4 ohms at 1 kHz, 10% THD) Other models: The following are measured at AC 127 V, 60 Hz (Mexican model), AC 120 – 127 V or AC 220 – 240 V, 50/60 Hz (Other models) DIN power output (rated): 50 + 50 W (4 ohms at 1 kHz, DIN) Continuous RMS power output (reference): 60 + 60 W (4 ohms at 1 kHz, 10% THD) Inputs AUDIO IN: Sensitivity 250 mV, impedance 47 kilohms Outputs PHONES: Accepts headphones with an impedance of 8 ohms or more SPEAKER: Accepts impedance of 4 ohms CMT-SPZ55/SPZ50 European and Russian models: DIN power output (rated): 40 + 40 W (6 ohms at 1 kHz, DIN) Continuous RMS power output (reference): 50 + 50 W (6 ohms at 1 kHz, 10% THD) Music power output (reference): 50 + 50 W (6 ohms at 1 kHz, 10% THD) The following are measured at AC 220 – 240 V, 50/60 Hz DIN power output (rated): 30 + 30 W (6 ohms at 1 kHz, DIN) Continuous RMS power output (reference): 40 + 40 W (6 ohms at 1 kHz, 10% THD) Inputs AUDIO IN: Sensitivity 250 mV, impedance 47 kilohms Outputs PHONES: Accepts headphones with an impedance of 8 ohms or more SPEAKER: Accepts impedance of 6 ohms CD player section System: Compact disc and digital audio system Laser Diode Properties Emission Duration: Continuous Laser Output*: Less than 44.6.W * This output is the value measurement at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7mm aperture. Frequency response: 20 Hz – 20 kHz (±2 dB) Wavelength: 780 – 790 nm Tape deck section Recording system: 4-track 2-channel, stereo Frequency response: 50 – 13,000 Hz (±3 dB), using Sony TYPE I cassettes Wow and flutter: ±0.15% W. Peak (IEC) 0.1% W. RMS (NAB) ±0.2% W. Peak (DIN) Tuner section FM stereo, FM/AM superheterodyne tuner FM tuner section: Tuning range: 87.5 – 108.0 MHz Antenna: FM lead antenna Antenna terminals: 75 ohms unbalanced Intermediate frequency: 10.7 MHz AM tuner section: ...
Otros modelos de este manual:estéreo - CMT-SPZ50 (406.69 kb)
estéreo - CMT-SPZ55 (406.69 kb)