Votos - 3, Puntuación media: 3.7
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Speakers Sound comes from only one channel or the left and right volumes are unbalanced. •Check the speaker connections and placement. There is no sound from the surround speakers (LBT-D790/XB33/XB33K/XB50/ XB60 only). •Press SURROUND to turn on the surround effect. CD Player The CD tray does not rotate. •A CD is not placed properly. A CD will not play. •The CD is not lying flat in the disc tray. •The CD is dirty. •The CD is inserted label side down. •Moisture condensation has built up. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. Play does not start from the first track. •The player is in Program or Shuffle Play mode. Press PLAY MODE repeatedly until “PROGRAM” or “SHUFFLE” disappear from the display. Tape Deck The tape does not record. •No tape is in the cassette holder. •The tab has been removed from the cassette (see page 40). •The tape has reeled to the end. The tape does not record nor play, or there is a decrease in sound level. •The heads are dirty. Clean them (see page 40). •The record/playback heads are magnetized. Demagnetize them (see page 40). The tape does not erase completely. •The record/playback heads are magnetized. Demagnetize them (see page 40). There is excessive wow or flutter, or the sound drops out. •The capstans or pinch rollers are dirty. Clean them (see page 40). Noise increases or the high frequencies are missing. •The record/playback heads are magnetized. Demagnetize them (see page 40). Tuner Severe hum or noise (“TUNED” or “STEREO” flashes in the display). •Adjust the antenna. •The signal strength is too weak. Connect an external antenna. A stereo FM program cannot be received in stereo. •Press STEREO/MONO so “STEREO” appears in the display. If other problems not described above occur, reset the system as follows: (LBT-D390/D790/G5500/XB33/XB33K/ XB44/XB44K/XB50/XB60 only) 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press GROOVE, ENTER/NEXT, and DISC 1 at the same time. (LBT-XB66/XB66K/XB660 only) 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press SPECTRUM ANALYZER, ENTER, and DISC 1 at the same time. Specifications For the U.S. model AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 8 ohm loads, both channels driven, from 70 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.9% total harmonic distortion from 250Emilliwatts to rated output. Amplifier section (LBT-D390/D790/G5500) Continuous RMS power output 120 + 120 watts (8 ohms at 1 kHz, 10% THD) Total harmonics distortion Less than 0.07% (8 ohms at 1 kHz, 50 W) (LBT-XB50) DIN power output (Rated) 80 + 80 watts (8 ohms at 1 kHz, DIN) Continuous RMS power output (Reference) 100 + 100 watts (8 ohms at 1 kHz, 10% THD) Music power output (Reference) 170 + 170 watts (8 ohms at 1 kHz, 10% THD) (LBT-XB60) DIN power output (Rated) 100 + 100 watts (8 ohms at 1 kHz, DIN) Continuous RMS power output (Reference) 120 + 120 watts (8 ohms at 1 kHz, 10% THD) Music power output (Reference) 210 + 210 watts (8 ohms at 1 kHz, 10% THD) (LBT-XB33/XB33K) The following measured at AC 120/240 V, 50 Hz DIN power output (Rated) 100 + 100 watts (6 ohms at 1 kHz, DIN) Continuous RMS power output (Reference) 120 + 120 watts (6 ohms at 1 kHz, 10% THD) Peak music power output (Reference) 1,500 watts (LBT-XB44/XB44K) The following measured at AC 120/240 V, 50 Hz DIN power output (Rated) 120 + 120 watts (6 ohms at 1 kHz, DIN) Continuous RMS power output (Reference) 140 + 140 watts (6 ohms at 1 kHz, 10% THD) Peak music power output (Reference) 2,000 watts (LBT-XB66/XB66K/XB660) The following measured at AC 120/240 V, 50 Hz DIN power output (Rated) 140 + 140 watts (8 ohms at 1 kHz, DIN) Continuous RMS power output (Reference) 170 + 170 watts (8 ohms at 1 kHz, 10% THD) Peak music power output (Reference) 3,000 watts Inputs PHONO IN (phono jacks): sensitivity 3 mV, impedance 47 kilohms MIX MIC (phone jack): sensitivity 1 mV, impedance 10 kilohms (LBT-D390/D790/G5500) VIDEO (AUDIO) IN (phono jacks): sensitivity 250 mV, impedance 47 kilohms (LBT-XB33/XB33K/XB44/XB44K/XB50/XB60/ XB66/XB66K/XB660) VIDEO/MD (AUDIO) IN (phono jacks): sensitivity 250 mV, impedance 47 kilohms Outputs PHONES (stereo phone jack): accepts headphones of 8 ohms or more (LBT-XB33/XB33K/XB44/XB44K/XB50/XB60/ XB66/XB66K/XB660) VIDEO/MD (AUDIO) OUT (phono jacks): voltage 250 mV, impedance 1 kilohm SPEAKER: (LBT-D390/D790/G5500/XB50/XB60/XB66/ XB66K/XB660) accepts impedance of 8 to 16 ohms. (LBT-XB33/XB33K/XB44/XB44K) accepts impedance of 6 to 16 ohms. SURROUND SPEAKER (LBT-D790/XB33/XB33K/XB50/XB60 only) accepts impedance of 16 ohms AM tuner section Tuning range (2 band model) North American model: 530 – 1,710 kHz (with the tuning interval set at 10 kHz) 531 – 1,710 kHz (with the tuning interval set at 9 kHz) Other models: 531 – 1,602 kHz (with the tuning interval set at 9 kHz) 530 – 1,710 kHz (with the tuning interval set at 10 kHz) (3 band and 4 band models) MW: 531...
Otros modelos de este manual:estéreo - LBT-D390 (854.96 kb)
estéreo - LBT-D790 (854.96 kb)
estéreo - LBT-XB33 (854.96 kb)
estéreo - LBT-XB33K (854.96 kb)