Votos - 2, Puntuación media: 4 ( )

Fabricar: VocoPro Tamaño del archivo: 1.56 mb Nombre del archivo: da3050k.pdf Idioma del manual:

VOLUME CONTROL 5. AUTO KEY RESET 6. DIRECT ACCESS DIGITAL KEY CONTROL 7. VOCAL CANCEL 8. VOCAL PARTNER 9. DIGITAL KEY CONTROL i FRONT PANEL : © 1.POWER SWITCH PRESSING THIS SWITCH TURNS ON THE POWER. PRESSING THIS SWITCH AGAIN TURNS OFF THE POWER 2.DIGITAL ECHO REPEAT AND DELAY CONTROL CONTROL THE ECHO CHARACTERISTICS OF MIC. 1,2,3. DELAY: ADJUSTS THE TIMING OF THE ECHO. REPEAT: ADJUSTS THE REPETITION INTERVAL OF THE ECHO. 3.DIGITAL ECHO CONTROL CONTROLS THE DIGITAL ECHO LEVELS FOR MIC. 1,2,3 SIMULTANEOUSLY. 4.M1C. BASS AND TREBLE CONTROL ADJUSTS THE TONE (BASS/TREBLE) OF THE MIC. 5.M1C.1 ~ MIC.3 VOLUME CONTROL TO ADJUST THE RESPECTIVE MIC. LEVEL INDEPENDENTLY. 6.MIC AND KEY CONTROLLER JACKS THREE MIC. CAN OPERATE SIMULTANEOUSLY. WHEN USING A MIC. WITH KEY CONTROL SWITCH, CONNECT THE MIC CABLE TO MIC. 1,2, 3 JACK, AND CONNECT THE KEY CONTROL CABLE TO THE KEY CONTROL JACK. PLEASE NOTE: A. WHEN CONNECTING THE MIC. KEEP THE VOLUME AT A LOWER LEVEL TO PROTECT THE SPEAKER AND AMP. B. THE SET POSITION OF THE KEY CONTROL MIGHT CHANGE WHEN THE CONTROL PLUG IS CONNECTED TO OR REMOVED FROM THE KEY CONTROLLER JACK. IN SUCH A CASE,RESET TO THE DESIRED POSITION. 7.VOCAL CANCEL USE THIS MODE TO CANCEL THE LEAD VOCAL ON KARAOKE MULTIPLEX DISC OR TAPE. PLEASE NOTE: THIS FEATURE MAY NOT WORK ON SOME DVD OR LD KARAOKE DISC. IN THIS CASE, USE THE AUDIO CONTROL ON THE DVD OR LD PLAYER TO CANCEL THE VOCAL. FRONT PANEL 8.VOCAL PARTNER USE THIS MODE FOR SINGING RELAY WITH THE VOCALIST ON KARAOKE MULTIPLEX DISC OR TAPE. THE VOCAL ON THE KARAOKE DISC OR TAPE WILL ONLY BE CANCELLED WHEN SINGING INTO THE MIC. PLEASE NOTE: THIS FEATURE MAY NOT WORK ON SOME DVD OR LD KARAOKE DISC. 9.KEY CONTROL AUTO RESET USE THIS MODE TO RESET KEY CONTROL BACK TO STANDARD PITCH AFTER EACH SONG. 10.KEY CONTROL BUTTONS PRESS TO CHANGE THE PITCH OF THE MUSIC SOURCE DIGITALLY CENTER: RESET TO THE STANDARD PITCH. UP #1~#6: RAISE THE MUSIC TO A MAXIMUM OF SIX 1/2 TONES ABOVE THE STANDARD KEY DOWN b1~b6: DECREASES THE MUSIC TO A MAXIMUM OF SIX 1/2 TONES BELOW THE STANDARD KEY. 11.INPUT SELECTOR/INDICATORS SELECT AND DISPLAYS THE INPUT SOURCE SIGNALS YOU WISH TO PLAY. 12.LEFT/RIGHT CHANNEL LEVEL INDICATOR DISPLAY THE INPUT LEVEL OF THE MUSIC BEEN PLAYED. 13.POWER INDICATOR LIGHT DISPLAYS THE UNIT IS TURN ON OR OFF. 14.KEY CONTROL INDICATOR DISPLAYS THE KEY OF THE UNIT IS BEEN SETAT. 15.REMOTE SENSOR 16.MIC. MASTER VOLUME CONTROLS THE OVERALL VOLUME OF THE MIC. 1,2 AND 3. 17.MUSIC VOLUME CONTROL CONTROLS THE MUSIC VOLUME OF THE INPUT SOURCE BEEN SELECTED (DVD PLAYER, CDG PLAYER, LD PLAYER OR TAPE PLAYER. REAR PANEL CD 8 o o o o o o o o ou4 00° ♦>o o MJOO KVT TPMIL '^¿n7^/W/Fy/7~/Z27 Of d t+a+r, bdhnfa ILUL AMs-HAI oaruET USSWTTCHED © FUSE a : iiTv/BOKr ©■ © w 1. VIDEO OUTPUT JACKS CONNECT TO THE VIDEO INPUT JACK OF A TV MONITOR UP TO THREE TV MONITOR CAN BE CONNECTED AND DISPLAYED SIMULTANEOUSLY 2. VIDEO INPUT JACKS DVD : CONNECT TO THE VIDEO OUTPUT JACKS OF A DVD PLAYER. CDG : CONNECT TO THE VIDEO OUTPUT JACKS OF A CDG PLAYER. LD : CONNECT TO THE VIDEO OUTPUT JACKS OF A LASER DISC PLAYER. 3. RECORD OUTPUT JACKS CONNECT TO THE AUDIO INPUT JACKS OF A RECORDING DEVISE (TAPE PLAYER, MD PLAYER...). NOTE: USE RECORD OUT TO RECORD MUSIC. USE PRE OUT TO RECORD MUSIC AND VOCAL. 4. AUDIO PRE OUT JACKS CONNECT TO THE AUDIO INPUT JACKS OF A POWER AMPLIFIER OR A RECEIVER. 5. FUSE HOLDER 6. AUDIO INPUT JACKS CONNECT TO THE AUDIO OUTPUT JACKS OF THE SOURCE PLAYER. (DVD PLAYER, LASER DISC PLAYER, CDG PLAYER, TAPE PLAYER. ) 7.AC OUTLETS (UNSWITCHED) 8.POWER CORD 4 TROUBLE SHOOTING INCORRECT OPERATIONS ARE OFTEN MISTAKEN FOR TROUBLE AND MALFUCTIONS. IF YOU THINK THAT THERE IS SOMETHING WRONG WITH THIS COMPONENT, CHECK THE POINTS BELOW. SOMETIMES THE TROUBLE MAY LIE IN ANOTHER COMPONENT INVESTIGATE THE OTHER COMPONENTS AND ELECTRICAL APPLIANCES BEING USED. IF THE TROUBLE CANNOT BE RECTIFIED EVEN AFTER EXERCISING THE CHECKS LISTED BELOW, CONTACT YOUR DEALER OR VOCOPRO TO CARRY OUT REPAIR WORK. SYMPTOM ! CAUSE REMEDY NO SOUND COMING FROM OF SPEAKER/S • POWER CORD IS UNPLUGGED • NO INPUT IS COMING FROM THE INPUT SELECTOR OR THE INPUT IS SWITCHED INCORRECTORY BETWEEN THE MIXER AND THE AMP. • PLUG CORD INTO A WALL OUTLET • SELECT THE CORRECT INPUT FOR THE SPECIFIC UNIT THAT YOU WANT TO PLAY. MICROPHONE IS NOT ■)RKING w • MICROPHONE IS UNPLUGGED. • MICROPHONE VOLUME IS SET AT A MINIMUM LEVEL. • INPUT OF THE AMP. IS NOT SET CORRECTLY. • PLUG THE MICROPHONE COMPLETELY INTO THE TERMINAL. • ADJUST LEVELS BY USING THE MICROPHONE VOLUME CONTROL. • SELECT THE CORRECT INPUT ON THE AMP. OR RECEIVER. REMOTE CONTROL DOES NOT WORK V • THERE ARE NO BATTERIES IN THE REMOTE OR THE REMAINING SERVICE LIFE IS LOW. • A FLUORESCENT LAMP IS NEAR THE REMOTE CONTROL SENSOR. • THE DISTANCE TO THE AMPLIFIER IS TOO FAR, OR THE REMOTE CONTROL IS POINTED AT AN IMPROPER ANGLE. • AN OBSTACLE EXISTS BETWEEN THE REMOTE CONT...

Descargar ahora

Introduzca dos números de la imagen: