Votos - 6, Puntuación media: 4.5
(
)
)
|
Resumen del manual
2: GAIN: Use this control to adjust the amount of distortion for the Solo channel. 3: LEVEL: Use this control to adjust the output level of the Solo channel. 4: SOLO/CLEAN: Use this switch to select the Solo or Clean channel. With the switch in the out position, the Clean channel is selected. When the switch is depressed, the Solo channel is selected. CLEAN CHANNEL: A normal gain channel designed to give you crystal clear sounds to medium distortion. 5: VOL: Use this control to adjust the output level of the Clean channel. 6: LOW: Use this control to adjust the low frequency level of the amplifier. 7: MID: Use this control to adjust the midrange frequency level of the amplifier. 8: HIGH: Use this control to adjust the high frequency level of the amplifier. 9. REV LEVEL (GT15R only): Use this control to adjust the level of reverb effect. 8 9 101112 13 10: CD INPUT: Use these RCA jacks to connect the output from a CD player or tape deck to the amplifier. The signal at these jacks is combined into a mono signal which is sent to the internal power amp circuit. Use the CD or tape player’s output level control to adjust the signal for the proper mix with your guitar. 11: HEADPHONES: Use this jack to connect headphones to the amplifier. The internal speaker is disconnected when headphones are used. CAUTION: To avoid possible damage to your hearing, do not use headphones for extended periods of time at extremely loud levels. 12: SPEAKER: Use this jack to connect the amplifier to an external speaker. The internal speaker is disconnected when this jack is used. The impedance of the external speaker must be 4 ohms or greater. WARNING: Do not attempt to use headphones in the Speaker jack! Permanent hearing damage could result! 13: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed). The switch illuminates when the amplifier is turned on. 14: POWER CORD (rear panel, not shown): The grounded power cord should only be plugged into a grounded power outlet that meets all applicable electrical codes and is compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection. GT15/15RGuitar Amplifier SPECIFICATIONS: 12W RMS @ 5% THD, 4., 120 VAC Solo Ch 86dB +/-6dB @ 1kHz Clean Ch 46dB +/-6dB @ 1kHz 26dB +/-2dB Accepted 2.2 volts RMS min. @ 400Hz Low 25dB range @ 80Hz Mid 19dB range @ 900Hz High 23dB range @ 5kHz Solo Ch >50dB Clean Ch >65dB 8” Crate Custom Design 4 ohm 120 VAC, 60Hz, 30VA 100/115VAC, 50/60Hz, 30VA 230VAC, 50/60Hz, 30VA 13” H x 13-5/8” W x 8-1/4” D, 15 lbs. and information in this manual are subject to change without notice. Declaration Of Conformity #27, Effective 01-01-2001 Manufacturer’s Name: SLM Electronics Production Facility: 11880 Borman Drive, St. Louis, MO 63146, USA Production Facility: 700 Hwy 202 W, Yellville, AR 72687, USA Shipping Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA Office Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA Product Type: Audio Amplifier Complies with the following Standards: Safety: EN60065, E60065, C22.2, UL6500 and/or UL813 EMC: Directive 89/336/EEC, EN55103, EN55013, EN61000, and/or FCC 47CFR 15B clA Supplementary information provided by: SLM Electronics - R & D Engineering 1901 Congressional Drive, St Louis, MO 63146, USA Tel.: 314-569-0141, Fax: 314-569-0175 • 1400 Ferguson Avenue • St. Louis, MO 63133 47-447-04 • 052703 ...
Otros modelos de este manual:Instrumentos Musicales - GT15R (113.82 kb)