Votos - 2, Puntuación media: 5
(
)
)
|
Resumen del manual
dd,...,ee = data: 00H-7FH (0-127) F7H: EOX (End Of Exclusive) The System Exclusive Messages received by the HP-147 are; Universal Non-realtime System Exclusive messages, and Data Set (DT1). l Universal Non-realtime System Exclusive Messages m Identity Request Message Status Data byte Status F0H 7FH, dev, 06H, 01H F7H Byte Explanation FOH Exclusive status 7FH ID number (universal non-realtime message) dev Device ID (dev: UNIT#-1) 06H Sub ID#1 (General Information) 01H Sub ID#2 (Identity Request) F7H EOX (End Of Exclusive) * When Identity Request is received, Identity Reply message will be transmitted. * Even if the Device ID is 7FH(Broadcast), Identity Reply message will be transmitted. * The "dev" is own device number (UNIT#-1) or 7FH (Broadcast). * UNIT# is always the same as the current MIDI Tx/Rx channel. l Data transmission HP-147 can transmit and receive the various parameters using System Exclusive messages. The exclusive message of HP-147 data has a model ID of 1AH, and device ID is defined by MIDI UNIT NUMBER. UNIT NUMBER is always the same as the current MIDI Tx/Rx channel. m Data set 1 DT1 This is the message that actually performs data transmission, and is used when you wish to transmit the data. Status Data byte Status F0H 41H, dev, 1AH, 12H, aaH, bbH, ddH, sum F7H Byte Explanation F0H Exclusive status 41H ID number (Roland) dev Device ID (dev: UNIT#-1) 1AH Model ID (HP-147) 12H Command ID (DT1) aaH Address MSB: upper byte of the starting address of the transmitted data bbH Address LSB: lower byte of the starting address of the transmitted data ddH Data: the actual data to be transmitted. sum Checksum F7H EOX (End Of Exclusive) * If "Data Set 1" is transmitted successively, there must be an interval of at least 40 msec between packets. * Regarding the address please refer to section 3 (Parameter Address Map). * Regarding the checksum please refer to section 4 (Supplementary material). 2. Transmit Data n Channel Voice Messages l Note off Status 2nd byte 3rd byte 8nH kkH 40H n = MIDI channel number: 0H-FH (ch.1-ch.16) kk = note number: 0FH-71H (15-113) l Note on Status 2nd byte 3rd byte 9nH kkH vvH n = MIDI channel number: 0H-FH (ch.1-ch.16) kk = note number: 0FH-71H (15-113) vv = note on velocity: 01H-7FH (1-127) * Note number's range can be changed with Key Transpose and Octave Shift. l Control Change * The value specified by a Control Change message will not be reset even by a Program Change, etc. m Data Entry (Controller number 6, 38) Status 2nd byte 3rd byte BnH 06H mmH BnH 26H llH n = MIDI channel number : 0H-FH (ch.1-ch.16) mm, ll = the value of the parameter specified by RPN * Data Entry is sent through the basic channel. m Hold 1 (Controller number 64) Status 2nd byte 3rd byte BnH 40H vvH n = MIDI channel number : 0H-FH (ch.1-ch.16) vv = Control value: 00H,7FH (0, 127) 0 = OFF, 127 = ON m Sostenuto (Controller number 66) Status 2nd byte 3rd byte BnH 42H vvH n = MIDI channel number: 0H-FH (ch.1-ch.16) vv = Control value: 00H,7FH (0, 127) 0 = OFF, 127 = ON m Soft (Controller number 67) Status 2nd byte 3rd byte BnH 43H vvH n=MIDI channel number: 0H-FH (ch.1 - ch.16) vv=Control value: 00H,7FH (0, 127) 0 = OFF, 127 = ON m Effect 1 (Reverb Send Level) (Controller number 91) Status 2nd byte 3rd byte BnH 5BH vvH n=MIDI channel number: 0H - FH (ch.1 - ch.16) vv=Control value: 00H,7FH (0, 127) 0 = OFF, 127 = ON m RPN MSB/LSB (Controller number 100, 101) Status 2nd byte 3rd byte BnH 65H mmH BnH 64H llH n = MIDI channel number : 0H-FH (ch.1-ch.16) mm = upper byte of parameter number specified by RPN ll = lower byte of parameter number specified by RPN * RPN is sent through the basic channel. **RPN** 3. Parameter Address Map (Model ID = HP-147 can transmit Master fine tuning (RPN #1) and RPN null. After sending the master fine tune, immediately the RPN Null shall be sent. 1AH) RPN Data entry All the numbers of address, size, Data, and Default Value are indicated in 7-bit MSB LSB MSB LSB Explanation Hexadecimal-form. 00H 01H mmH llH Master Fine Tuning mm, ll: 00 00H - 40 00H - 7F 7FH +---------------------------------------------------------------+ (-100 - 0 - +99.9 cents) | Address(H) | Description | 7FH 7FH --- ---RPN null |------------+--------------------------------------------------| | 01 03 | 0aaa aaaa | Reverb Type | | | | 00H - 0FH : Type 1 | . Program Change | | | 10H - 1FH : Type 2 | | | | 20H - 2FH : Type 3 | Status 2nd byte | | | 30H - 3FH : Type 4 | CnH ppH | | | 40H - 4FH : Type 5 | | | | 50H - 5FH : Type 6 | | | | 60H - 6FH : Type 7 | n = MIDI channel number: 0H-FH (ch.1-ch.16) | | | 70H - 7FH : Type 8 | +------------+--------------------------------------------------+ pp = Program number: 00H..21H (prog.1..prog.34) * For the correspondence between Program Change numbers and Tones, please refer to "Program Change" in "1.Receive Data." 4. Supplementary material n System Realtime Message l Decimal and Hexadecimal table In MIDI documentation, data values and addresses/sizes of exclusive me...