Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
PRECAUTIONS Read these precautions carefully before using your speaker. . Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier to be driven into “clipping”. Otherwise the speaker may be damaged. . When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be taken never to exceed the speaker’s maximum input. . Do not attempt to clean the speaker with chemical solvents as this might damage the finish. To clean, wipe with a dry, soft cloth. . To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity. . Do not place the speaker where it is liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance. . Secure placement or installation is the owner’s responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of the speaker. PLACING THE SPEAKER The rear center speaker should be placed behind the listening position, and equidistant from the two surround speakers. The positioning of the rear center speaker is important, because it controls the whole sound quality of a multi channel system. REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four points, and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inside surface of the cover with the four corresponding holes on the speaker and push gently. Note When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools. SPECIFICATIONS Surround R Main R Main L Center Surround L NS-100S (Rear center speaker) Subwoofer Type .......................... 2-way 2-speaker bass reflex speaker system (Magnetically-shielded type) Speaker Unit ............................................ 16 cm (6.5”) cone woofer 3 cm (1”) dome tweeter Nominal Impedance ............................................................. 6 ohms Frequency Response ...............................................38 Hz – 35 kHz Nominal Input Power .............................................................. 100 W Maximum Input Power ........................................................... 300 W Sensitivity ................................................................ 90 dB/2.83 V/m Crossover Frequency .............................................................. 3 kHz Dimensions (W x H x D) ................................... 212 x 416 x 270 mm (8.3” x 16.4” x 10.6”) Weight ................................................................... 8.6 kg (19.0 lbs.) . Specifications subject to change without notice due to product improvements. . Care should be taken not to exceed the input power values noted above. CONNECTIONS TO YOUR AMPLIFIER CONNECTIONS TO YOUR AMPLIFIER This speaker system is capable of standard connections and bi-wiring connections. Before making connections, make sure that the amplifier is switched off.