Votos - 2, Puntuación media: 3
(
)
)
|
Resumen del manual
Internal jumpers allow the AUX 1 control to be rewired for pre-EQ/pre-fader or post-EQ/pre-fader operation-REFER THIS JOB TO YOUR YAMAHA DEALER OR A QUALIFIED SERVICE CENTER! G Channel Fader This is the main level control for each input channel. It determines the level of the signal sent from the corresponding input channel to the master mixing buss and to the mixer's power amplifier via the master fader. The settings of the input channel faders determines the "mix” or balance of sound levels between the instruments or other sources connected to the inputs. * If a channel is not being used, its fader should be set to the minimum position to prevent unwanted noise from being added to the main program signal. 4 /MASTER CONTROL SECTION/ 0SEND 1 & SEND 2 Faders These adjust the overall output level of the AUX 1 and AUX 2 "mixes" set up using the AUX 1 and AUX 2 controls. SEND 1 sets the overall level of the AUX 1 mix signal appearing at the AUX SEND 1 jack, and SEND 2 sets the overall level of the AUX 2 mix signal appearing at the AUX SEND 2 jacks (there are two AUX SEND 2 jacks). These controls should be used to optimally match the AUX SEND output level of the mixer to the input sensitivity of the external effect, signal processing device or power amplifier used. 0 AUX RTN 1 & AUX RTN 2/REV controls These controls adjust the level of the signal received at the corresponding rear-panel AUX RTN jacks and mixed into the main program. If no plug is inserted into the AUX RTN 2 jack, the AUX RTN 2 /REV control adjusts the level of the reverb signal from the internal reverb system mixed into the main program. If, however, an external effect device is inserted into the AUX 2 RTN jack, the internal reverb system will be bypassed. 0 Graphic Equalizer & EQ Switch This 6-band graphic equalizer allows fine response shaping of the main output. It has 6 linear controls with center frequencies of 250 Hz, 500 Hz, 1 kHz, 2 kHz, 4 kHz and 8 kHz. Each control permits a maximum boost or cut of 12 dB. When set to the center or "0" position, response in the corresponding band is unaffected. The EQ switch turns the graphic equalizer ON or OFF. 0 MASTER Fader The MASTER fader is the main "volume .control" for the overall program mix, controlling the level of the signal sent to th.e rear-panel SPEAKER OUT 1 & 2 jacks as well as the front-panel PHONES jack. 0 VU Meter Displays the VU level of the signal appearing at the output of the mixer's power amplifier. The meter is a useful aid in setting optimum output level using the MASTER fader. 0 PHONES Jack The PHONES jack delivers the main program signal to a pair of 8 ohm stereo or mono monitor headphones. The MASTER fader adjusts the headphone monitoring level. 5 REAR PANEL CONNECTORS AND CONTROLS <®i CAUTION 'ffif EACH SPEAKER IMPCOANCE - POWERPRIMARY FUSE f—
Instrumentos Musicales - EM1600 (744.89 kb)
Instrumentos Musicales - EM1800 (744.89 kb)