Votos - 2, Puntuación media: 3.5
(
)
)
|
Resumen del manual
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference. Features • Guaranteed low oil carryover rate of less than 2 PPM • Three year warranty on compressor pump • Isolation pads • Optional R134 dryer • ASME tank • UL listed controls Figure 1 - AS-XXX 1 Hp Simplex Air Compressor The AS-XXX Series Powerex Simplex Air Compressors have been designed, broken- in and tested to meet the most Specifications demanding specifications in the pneumatic climate control industry for low oil carryover and long life. All Powerex air compressors have reliable operation and feature high quality construction and components. An unloading feature is included on all compressors to provide loadless starting. Oil entrainment is minimized by the use of lap joint piston rings, low compressor speeds and a special lubricating oil with a high flash point and low carbon content. All 1/2 through 10 hp models are also equipped with an auxiliary cooling fan and air control shroud to achieve low head temperatures and further minimize oil carryover. Powerex compressor motors are NEMA Class B design. Single-phase motors have built-in overload protection and a DPST disconnect switch. Three-phase motors require a manual or magnetic starter and three overload heater coils which may be ordered as a factory mounted and wired option. Product AS-XXX Series Powerex Simplex Air Compressors Performance Specifications See Table 1 Models & Options See Table 2 Lubrication 1/2 Through 10 Splash Lubrication System Operating 1O 115 - 208/230 Volts, 60 Hz Voltages 3O 208-230/460 Volts, 60 Hz Compression 1/2 Through Cycle 10 Hp Models Single-Stage Motor Overload 1O Built-In Thermal Overload (Standard) Protection 3O Magnetic Starter and Three Thermal Overload Switches (Optional) Pressure Settings Cut-In: Factory Set at Approximately 70 psig (490kPa) Cut-out: Factory Set at Approximately 90 psig (630 kPa) Overpressure Protection ASME Safety Valve Factory Set and Sealed at Approximately 115 psig (805 kPa) Outlet Air 1/2" NPT on 30, 60 and 80 Gallon Tanks; Connections 1" NPT on 120 and 200 Gallon Tanks Tank Sizes See Table 2 California Ordinance 462 (L) (2) Meets Requirements of this Ordinance Tank Isolation Standard All Units Manuals 200 Page Service Manual Available The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these specifications, consult the local Powerex office. Powerex shall not be liable for damages resulting from misapplication or misuse of its products. Powerex • 150 Production Drive • Harrison, OH 45030 • USA IN259601AV 10/04 Climate Control Simplex TABLE 1: AS-XXX SERIES POWEREX SIMPLEX AIR COMPRESSORS PERFORMANCE SPECIFICATIONS Base Actual Hp Motor Rating Compressor Compressor Capacity ACFM* Model 1O 3O Hp RPM RPM 100% Runtime 50% Runtime 33% Runtime AS-105 .54 — — 1725 800 1.8 0.9 0.6 AS-005 — .54 .54 1720 AS-107 .73 — — 1725 1040 2.5 1.25 0.83 AS-007 — .73 .73 AS-110 1.07 — — AS-010 — 1.07 1.07 1725 625 3.8 1.9 1.25 AS-015 — 1.54 1.54 1750 955 6.4 3.2 2.11 AS-020 — 2.0 2.0 1750 800 8.6 4.3 2.84 AS-030 — 3.1 3.1 1745 775 12.0 6.0 4.0 AS-050 — 5.6 5.6 1745 690 22.0 11.0 7.33 AS-075 — 8.2 8.2 1745 795 28.5 14.3 9.44 AS-100 — 10.3 10.3 1750 685 43.0 21.5 14.2 Mounted and Connected Options MAGNETIC MOTOR STARTER An optional magnetic motor starter which has been selected and wired for the intended input voltage is available for all units. All starters are furnished with properly sized overload heaters. REFRIGERATED AIR DRYER A factory mounted Model Hankinson HPR 5-10 Series refrigerated air dryer with automatic condensate drain trap assembly, bypass valve is available as an option on all 1/2 through 3 Hp Powerex Simplex air compressors. Piping for air dryer is done at the factory. Wiring to power source must be done in the field using integral cord and plug which fits into a standard 120 volt receptacle. Refer to Table 2 for ordering details. AUTOMATIC TANK DRAIN Powerex air compressors are ordered with either a manual or electric type automatic tank drain. This unit is furnished with a manual drain attachment. VIBRATION DAMPENING PADS Waffle type design vibration pads are provided as standard equipment. Operation Factory calibrated snap-acting DPST pressure electric switches provide automatic cut-in and cut-out. Overpressure protection is provided by an ASME safety relief valve. Receiver tanks have a condensate drain valve with an extension for easy access. All mounting bases are slotted for V-belt tension adjustment to aid in maintaining proper compressor and motor alignment. All units are run through the factory break-in and are tested for air delivery, leakage and power consumption. Units are shipped with a proper fill of compressor oil in the crankcase and are furnished with an intake filter/silencer with a replaceable cartridge. T...