Votos - 3, Puntuación media: 5
(
)
)
|
Resumen del manual
At the selected mounting site, the Sat jointed mast tripod with the mounted planar antenna BAS 60 or BAS 61 should not put you are others in danger. Ensure that the coaxial cable is laid in such a manner, that nobody can stumble over it and injury themselves. Mounting steps Open up the three-legged Sat jointed mast tripod. Attention! Make sure that you do not pinch your fingers when closing the tripod. Tighten the milled nut. Mount the planar antenna onto the jointed head. Loosen the cross grip screw to set the azimuth, and align the antenna to the satellite (south) by turning the jointed head. Afterwards, lightly tighten the cross grip screw. Align the tripod vertically. Cable Strip the cable according to the illustration. Screw on the supplied connector, and connect the cable to the antenna. If a cable longer than 10 m is needed, connect an additional cable (not included in the scope of delivery) by means of the supplied coupling part. Ensure that none of the fine wires of the shield braid come into contact with the centre conductor of the cable when fitting the cable to the connector. This leads to poor picture quality. Lay and connect the coaxial cable from the planar antenna to the television set. Switch on the receiver and the TV set, and select the programme. Azimuth/elevation setting (Lateral alignment and elevation setting of the antenna) Obtain the elevation angle for your mounting site from the supplied table and appropriately align the antenna by loosening the cross grip nut on the jointed head. A graduation line on the jointed mast complies with 10°. Loosen the cross grip screw on the shaft of the jointed head, and adjust the antenna for picture reception by turning the jointed head to the right and the left (azimuth). Fine alignment of azimuth/elevation Repeat the alignment of the elevation and azimuth until the best picture quality is achieved. Afterwards, tighten the cross grip screw and the cross grip nut. We hope you have great reception! Cross grip nut ELEVATION Cross grip screw AZIMUTH Internet: KATHREIN-Werke KG · Anton-Kathrein-Stra.e 1–3 · Postfach 10 04 44 · D-83004 Rosenheim · Deutschland · Telefon (0 80 31) 18 40 · Telefax (0 80 31) 18 43 06 936.2164/Subject Mat trepied articule HDS 150 20410003 Le mat trepied articule HDS 150 sera utilise s.il n.y a pas de “visibilite directe” du satellite au lieu ou la caravane ou le camping- car est stationne. N.oubliez pas que des arbres, arbustes ou maisons qui masquent cette “visibilite directe” diminuent ou empechent la reception. Etat de livraison Mat trepied articule Cable coaxial de 10 m de longueur, O 5,8 mm Deux connecteurs F Un couplage F Site de l.antenne et pose de cable Selectionnez pour votre antenne satellite un lieu ou vous pouvez positionner l.antenne vers le Sud et ou existe une vue degagee vers le satellite Veillez a ce que le mat trepied avec l.antenne plane BAS 60 ou BAS 61 ne gene pas au site ni constitue un obstacle pour vous ou autre personne Lors du montage de cable, assurenz-vous que personne ne peut trebucher sur le cable et peut se blesser Etapes de montage Depliez le trepied du mat articule. Attention! En repliant le trepied existe danger de contusion Serrez l.ecrou molete Montez l.antenne sur la tete articulee. Desserrez la poignee en croix pour effectuer l.ajustage Azimut et positionnez l.antenne par rotation de la tete articulee vers le satellite (Sud). Serrez d...