Votos - 3, Puntuación media: 3.3
(
)
)
|
Resumen del manual
....c cccco oooom mmmm w wwwww wwwww w....c cccca aaaab bbbbl lllle eeees ssssu uuuun nnnnl lllli iiiim mmmmi iiiit tttte eeeed dddd. ....c cccco oooom mmmm Introduction This Audio Unlimited™ .4GHz digital wireless speaker system utilizes the most advanced wireless technology to deliver dynamic, high-quality audio anywhere inside or outside your home. The wireless audio transmission travels freely through walls, floors and other solid objects. Simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and CD/MP3/ VCD/DVD players... to enjoy full-spectrum, lifelike sound without complicated wiring and installation. Features 1. 2.4GHz Frequency Hopping Spread Spectrum (FHSS) digital transmission. 2. 32-Channel scan-tuning between transmitter and receiver. 3. Audio output power up to 20 Watts RMS per channel. 4. SRS WOW provides deep, rich bass and creates a 3D surround effect to provide a superior audio experience. 5. Weather-resistant speaker and remote control. 6. Mood light effect. 7. Dual weather-resistant speaker driver (super bass and tweeter built-in). 8. UV resistant speaker and remote control. 9. Supports stereo audio (with optional additional speaker). 10. AUX In jack. 11. Operating distance up to 50 meters in open ares (less through walls and other obstructions). 12. Works through walls, floors and anywhere in the room. 13. Virtually interference-free stereo quality. 14. Auto volume level control. 15. Remote control unit. 16. Powered by 6 D batteries, or by included AC adapter. Package content i. 1 x RF transmitter ii. 1 x RF speaker iii. 1 x Remote control iv. 1 x ac adapter for transmitter v. 1 x ac adapter for speaker vi. 1 x RCA to RCA cable vii. 1 x user manual Transmitter Speaker Remote Control Installation Transmitter 1. Plug the included AC adapter into a standard wall outlet. 2. Insert the adapter connector plug firmly into the DC IN jack located on the rear panel of the transmitter base. 3. Extend the retractable audio cable located on the back panel of the transmitter and connect it to the output jack of virtually any audio source. Note : Do not fully extend the cable until ready to retract. 4. To retract the cable, pull it until it is fully extended and then allow it to feed back into the base. Speaker Receiver Battery Power 1. To operate the speaker using battery power, gently turn the speaker over and open the battery compartment cover located underneath. 2. Insert six (6) D alkaline batteries (not provided) into the battery compartment, observing proper +/-polarities as indicated. 3. Replace the battery compartment cover. AC Power 1. To operate the speaker using AC power, plug the included 12V power adapter into a standard wall outlet. 2. Insert the power adapter connector firmly into the DC IN jack located on the back panel of the speaker. Operation 1. To switch on the speaker, press the POWER button located on the front panel of the speaker. The GREEN power LED illuminates. 2. To switch off the speaker, press the POWER button again. Remote Control The remote control is ready to use with a factory-installed button cell battery. It can be stored in the recessed area on the front panel. Basic Operation 1. When the transmitter power adapter is connected and plugged into a standard wall outlet, the transmitter's GREEN led remains on. 2. To switch on the speaker, press the POWER button on the front panel of the speaker. The GREEN led illuminates. 3. Turn on the audio source the transmitter is turned off for less then 4 minutes, the blue LEDs on the transmitter and the speaker illuminate when the audio signal link between the two is made. 4. If the audio source connected to the transmitter is turned off for less than 4 minutes, the BLUE leds on the transmitter and the speaker remain on, but no sound is transmitted. When the audio signal returns to the transmitter, sound is transmitted again. 5. If no signal is detected for more than 4 minutes, the transmitter automatically turns off ; the BLUE leds on the transmitter and the speaker switch to GREEN. 6. If no signal is detected from the transmitter for more than 5 minutes, the speaker automatically shifts to Standby mode. 7. To turn on the speaker again during Standby mode, press the POWER button on remote control unit. 8. If no audio signal is detected from the transmitter for more than 15 minutes, the speaker automatically turns off. The GREEN led goes off. 9. To switch on the speaker, press the POWER button on the front panel of the speaker. 10. To switch off the speaker. Press the POWER button again. Mood Light For mood light effect, press the LIGHTS button on the speaker or remote control. SRS WOW® SRS WOW® is built into the transmitter and is always on while paying ...