Votos - 4, Puntuación media: 3.8 ( )

Fabricar: Toshiba Tamaño del archivo: 3.39 mb Nombre del archivo: Idioma del manual:

If you install or remove a memory module while the computer is in Standby or Hibernation mode, data will be lost. A memory module must be installed in slot A. Do not try to operate the computer with a memory module in slot B only. If you install a memory module that is incompatible with the computer, a beep will sound when you turn on the computer. If the module is installed in slot A, there will be a long beep followed by a short beep. If the module is in slot B, there will be a long beep followed by two short beeps. In this case, turn off the computer and remove the incompatible module. Your computer comes with enough memory to run most of today’s popular applications. You may want to increase the computer’s memory if you use complex software or process large amounts of data. Additional memory comes in various capacities (visit Toshiba’s Web site at toshiba.com for more information). There are two memory slots. Your system may have both slots occupied. If you use the computer for a long time, the memory modules will become hot. If this happens, let the modules cool to room temperature before you replace them. Getting Started Getting Started Installing additional memory (optional) You need a standard Phillips no. 1 screwdriver to install a memory module. To avoid damaging the computer’s screws, use a standard Phillips no. 1 screwdriver that is in good condition. If you are adding memory after you have started to use the computer, begin at step 1, otherwise skip to step 2. 1 Turn off the computer via the Start menu. See “Turn Off or Shut down command” on page 96. The operating system turns off the computer. 2 Unplug and remove any cables connected to the computer. 3 Close the display panel and turn the computer upside down to locate the memory slot cover. Memory slot cover Base of your Satellite computer 4 Using a standard Phillips no. 1 screwdriver, unscrew the screw that secures the memory slot cover, then remove the memory slot cover. 68 68 68 Installing additional memory (optional) Removing the memory slot cover 5 Put the screw and the cover in a safe place so that you can retrieve them later. The following figure shows the inside of the memory compartment. Viewing the inside of the memory compartment Getting Started Getting Started Installing additional memory (optional) 6 Remove the memory module from its antistatic packaging. Static electricity can damage the memory module. Before you handle the module, touch a grounded metal surface to discharge any static electricity you may have built up. To avoid damaging the memory module, be careful not to touch its gold connector bar (on the side you insert into the computer). 7 Holding the memory module by its edges so that the gold connector bar faces the slot, fit the module into the socket. 8 Gently put the memory module connector down at an angle and press down until the clips snap into place. Do not force the module into position. The memory module should be level when s...

Descargar ahora

Introduzca dos números de la imagen: