Votos - 1, Puntuación media: 5 ( )

Fabricar: Toshiba Tamaño del archivo: 2.69 mb Nombre del archivo: Idioma del manual:

Avoid touching the connectors on the memory module or on the computer. Grease or dust on the connectors may cause memory access problems. 13 Replace the memory module slot cover and the screw. 14 Re-insert the battery. For information on inserting the battery, see “Changing batteries” on page 114. 15 Turn the computer right side up. 16 Reconnect any cables. 17 Restart the computer. TECHNICAL NOTE: You must have at least one memory module installed for the computer to work. Getting Started Getting Started Adding memory You can now continue setting up the computer. When the operating system has loaded, you can verify that the computer has recognized the additional memory module. If you are adding an extra memory module after setting up the computer, verify that the computer has recognized it correctly as described in “Checking total memory” on page 62. Removing a memory module If you need to remove a memory module: 1 Complete steps 1–7 in “Installing a memory module” on page 56 to shut down the computer and open the memory module slot cover. Do not try to remove a memory module with the computer turned on. You can damage the computer and the device. Do not remove the memory module while the computer is in Standby mode. The computer could hang up the next time you turn it on and data in memory will be lost. In either of the above cases, the Standby configuration will not be saved. The following message appears when you turn on the power: Warning: Resume FailurePress Any Key To Continue If the computer hangs up when you turn it on, perform the following: Press the power button and hold it down for at least ten seconds, then turn the power on again. 2 Pull the clips away from the memory module. The memory module pops partially out of the slot. 3 Carefully remove the memory module from the slot. 62 62 62 Adding memory Sample removing the memory module 4 Replace the memory module slot cover and the screw. 5 Turn the computer over and restart it. TECHNICAL NOTE: You must have at least one memory module installed for the computer to work. Checking total memory When you add or remove a memory module, you can check that the computer has recognized the change. To do this: 1 Click Start, then click Control Panel. 2 Click Performance and Maintenance. 3 Click System. 4 The General tab view automatically appears and shows total memory. If the computer does not recognize the memory configuration, turn off the computer, remove the memory slot cover, and make sure the memory module is seated properly, as described in step of “Adding memory” starting on page 55. Getting Started Getting Started Using the TouchPad™ Using the TouchPad™ The TouchPad, the small, smooth square cutout located in front of the keyboard, is sensitive to touch and enables you to move the cursor with the stroke of a finger. Simply move your finger on the TouchPad in the direction you would like to move the cursor: . To move the cursor to the top of the page, push you...

Descargar ahora

Introduzca dos números de la imagen: