Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
l Light off — Battery in full charge mode with AC adapter present. l Blue light on — Battery in charge mode with AC adapter present. Battery Charge and Health To check the battery charge, press and release the status button on the battery charge gauge to illuminate the charge-level lights. Each light represents approximately 20 percent of the total battery charge. For example, if four lights are on, the battery has 80 percent of its charge remaining. If no lights appear, the battery has no charge. To check battery health using the charge gauge, press and hold the status button on the battery charge gauge for at least three seconds. If no lights appear, the battery is in good condition and more than 80 percent of its original charge capacity remains. Each light represents incremental degradation. If five lights appear, less than 60 percent of the charge capacity remains, and you should consider replacing the battery. Keyboard Status Lights The green lights located above the keyboard indicate the following: LED Error Codes The following table shows the possible LED codes that may display in a no-Power On Self Test (POST) situation. Turns on when you turn on the computer and blinks when the computer is in a power management mode. Turns on when the computer reads or writes data. Turns on steadily or blinks to indicate battery charge status. Turns on when wireless networking is enabled. Turns on when the numeric keypad is enabled. Turns on when the Caps Lock function is enabled. Turns on when the Scroll Lock function is enabled. Appearance Description Next Step ON-FLASH-FLASH No SODIMMs are installed 1. Install supported memory modules. 2. If memory is already present, reseat the module(s) one at a time in each slot. 3. Try known good memory from another computer or replace the memory. 4. Replace the system board. FLASH-ON-ON System board error 1. Replace the system board. FLASH-ON-FLASH Back to Contents Page LCD panel error 1. Reseat the LCD cable. 2. Replace the LCD panel. 3. Replace the video card/system board. OFF-FLASH-OFF Memory compatibility error 1. Install compatible memory modules. 2. If two modules are installed, remove one and test. Try the other module in the same slot and test. Test the other slot with both modules. 3. Replace the memory. 4. Replace the system board. ON-FLASH-ON Memory is detected but has errors 1. Reseat the memory. 2. If two modules are installed, remove one and test. Try the other module in the same slot and test. Test the other slot with both modules. 3. Replace the memory. 4. Replace the system board. FLASH-FLASH-FLASH System board error 1. Replace the system board. OFF-ON-OFF Storage device error 1. Reseat the hard drive. 2. Replace the hard drive. 3. Replace the system board. FLASH-FLASH-ON Video card error 1. Replace the system board. Back to Contents Page Adding and Replacing Parts Dell Latitude 2110 Service Manual Back to Contents Page Battery Access Panel Coin-Cell Battery WWAN Card Heatsink Display Assembly Display-Hinge Covers Display/Display Brackets Display Hinge Keyboard Memory WLAN Card Hard Drive/Hard-Drive Bracket DC Power Cable Display Bezel Camera Display Cable System Board/Bluetooth Module Back to Contents Page Specifications System Information Memory Audio Ports and Connectors Display Touchpad AC Adapter Physical Processor Video Communications Drives Keyboard Battery Environmental NOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Start® Help and Support and select the option to view information about your computer. System Information Chipset Intel NM10 Express Chipset DRAM bus width 64 bits Flash EPROM 2 MB PCI-e bus x1 PCI Express, 4 ports Processor Types Intel Atom L1 cache 32 KB per instruction, 24 KB write-back data cache L2 cache 512 KB Memory Type DDR2 SDRAM Speed 667 MHz Connectors one SODIMM slot Module capacities 1 GB, 2 GB Minimum memory 1 GB Maximum memory 2 GB Video Type Intel UMA graphics (integrated on the processor) Controller Intel Graphics Media Accelerator Output 15-pin VGA connector Audio Type two-channel integrated audio Controller Realtek ALC269 Speakers two Internal speaker amplifier 2 W per channel Volume controls media control buttons, program menus Communications Network adapter Gigabit Ethernet Wireless wireless local area network (WLAN) wireless wide area network (WWAN) worldwide Interoprability for microwave access (WiMAX) Bluetooth Ports and Connectors Audio microphone connector, stereo headphone/speakers connector Video 15-pin VGA connector Network adapter RJ-45 connector USB three USB 2.0-compliant connectors Memory card reader 3-in-1 memory-card reader Drives Hard drive 2.5" SATA 2 HDD Display Type WSVGA (1024 x 600 pixels) and HD (1366 x 768 pixels), high definition, anti glare (AG), white lightemitting diode (WLED) Size 10.1 inches Active area (X/Y) WSVGA 222.72 mm x 125.28 mm (8.76 inches x 4.93 inches) HD 222.73 mm x 125.22 mm (8.76 inches x 4.93 inches) Dimensions ...