Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
canadien pour la population. Consultez le Safety Code 6 sur le site Web du Ministére de la
santé canadien à l’adresse “www.hc‐sc.gc.ca/rpb”.
L’énergie émise par les antennes reliées aux adaptateurs sans fil respecte la limite d’exposition
aux radiofréquences telle que définie par Industrie Canada dans la clause 4.2 du document
CNR‐102.
Le gain dʹantenne maximal autorisépour les appareils dans les bandes de fréquence 5250‐5350
MHz, 5470‐5725 MHz et 5725‐5825 MHz est conforme àla limite p.i.r.e (puissance isotrope
rayonnée équivalente) définie dans la section A9.2 du CNR‐210.
Lorsque vous utilisez une carte de réseau local sans fil dans le mode de transmission 802.11
a/n:
• Les appareils destinés àla bande 5150‐5250 MHz devront être exclusivement utillsés en
intérieur afin de réduire les risques de perturbations électromagnétiques gênantes sur les
systèmes de satellite mobile dans un même canal.
• Les radars àforte puissance sont désignés comme les utilisateurs principaux (cʹest‐à‐dire
quʹils sont prioritaires) des bandes 5250‐5350 MHz et.
5650‐5850 MHz. lls peuvent provoquer des perturbations électromagnétiques sur les appar‐
eils de type LELAN (réseau de communication local sans licence) ou les endommager.
Electronic emission notices
Federal Communications Commission (FCC) Statement
Note: The compliance of the FCC Part 15 Subpart B for Models: 7260HMW BN, BCM943228HMB,
AR5B22 was proceeded by certification, thus the FCC ID: PD97260HU, QDS-BRCM1058, PPD-
AR5B22, respectively include both compliances of Part 15 Subpart B and C/E.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason‐
able protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult an authorized dealer or service representative for help.
Lenovo is not responsible for any radio or television interference caused by unauthorized
changes or modifications to this equipment. Unauthorized changes or modifications could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
4
...