Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
Back to Contents Page
Dell Diagnostics
Dell™ Inspiron™ 700m/710m Service Manual
When to Use the Dell Diagnostics
Starting the Dell Diagnostics
When to Use the Dell Diagnostics
If you experience a problem with your computer, perform the checks in the "Solving Problems" section in your User's Guide or Owner's Manual and run the Dell
Diagnostics before you contact Dell for technical assistance. Running the Dell Diagnostics may help you resolve the problem without contacting Dell. If you do
contact Dell, the test results can provide important information for Dell's service and support personnel.
The Dell Diagnostics allows you to:
l
Perform tests on one or all devices.
l
Select tests based on a symptom of the problem you are having.
l
Choose how many times a test is run.
l
Suspend testing if an error is detected.
l
Access help information that describes the tests and devices.
l
Receive status messages that tell you whether tests completed successfully.
l
Receive error messages if problems are detected.
Starting the Dell Diagnostics
NOTICE: Use the Dell Diagnostics to test your Dell™ computer only. Using this program with other computers can result in error messages.
The Dell Diagnostics is located on a hidden diagnostic utility partition on your hard drive.
NOTE: If your computer cannot display a screen image, contact Dell.
1.
Shut down the computer.
2.
Connect the computer to an electrical outlet.
3.
Turn on the computer. When the DELL™ logo appears, press
NOTE: If you cannot see anything on your display, hold down the
computer automatically runs the Pre-boot System Assessment.
NOTE: If you see a message stating that no diagnostics utility partition has been found, run the Dell Diagnostics from your Drivers and Utilities CD.
If you wait too long and the Microsoft® Windows® logo appears, continue to wait until you see the Windows desktop. Then shut down your computer
through the Start menu and try again.
4.
When the boot device list appears, highlight Diagnostics and press
The computer runs the Pre-boot System Assessment, a series of initial tests of your system board, keyboard, hard drive, and display.
l
During the assessment, answer any questions that appear.
l
If a failure is detected, the computer stops and beeps. To stop the assessment and restart the computer, press
test, press
l
If failures are detected during the Pre-boot System Assessment, write down the error code(s) and contact Dell before continuing on to the Dell
Diagnostics.
If the Pre-boot System Assessment completes successfully, you receive the message Booting Dell Diagnostic Utility Partition. Press any key to
continue.
5.
Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.
6.
When the Dell Diagnostics Main Menu appears, select the test you want to run.
...