Votos - 2, Puntuación media: 3 ( )

Fabricar: Husqvarna Tamaño del archivo: 3.55 mb Nombre del archivo: Idioma del manual:

Avoid spilling fuel. NOTE: Whenever possible, avoid using oxygenated fuels and fuels that are blended with alcohol. Vehicles to be stored for extended periods should be prepared for storage as instructed. See Preparing the Gasoline Vehicle for Extended Storage on page 29. 1. Turn the key switch to the OFF position. 2. Lift and remove seat bottom. 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 47 Cleaning the Vehicle 3. The fuel tank is located on passenger side of vehicle. Remove fuel cap and fill the fuel tank with fresh unleaded gasoline only. See preceding CAUTION. 4. Replace fuel cap on tank. Ensure cap is tightened securely. 5. Replace seat bottom. 1 3 2 Figure 32 Fuel Tank 1. Vent 2. Fuel Shut-off Valve 3. Vent Tube CLEANING THE VEHICLE Husqvarna vehicles are equipped with ABS front bodies and TPO for rear bodies. Use only commercially available automotive cleaners with a sponge or soft cloth for normal cleaning. A garden hose at normal residential water pressure is adequate. Husqvarna does not recommend any type of pressure washing or steam cleaning. Such a process (especially if the vehicle has the rear body removed) will expose electrical components to moisture. Moisture entering electrical components can result in water damage and subsequent component failure. Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should be removed immediately to prevent possible stains. The seats of the vehicle will last longer with proper cleaning. Use a solution of 10% liquid soap and warm water applied with a soft cloth. For imbedded dirt, a soft bristle brush may be used. For heavy soiling, difficult stains or scratches, blemishes, or other body damage, see Section 4 of the appropriate maintenance and service manual. NOTE: Dispose of waste water properly. Page 48 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Accessories ACCESSORIES There is a complete line of accessory equipment available from Husqvarna and our dealers/distributors. You can obtain the name and phone number of your closest Husqvarna contact by visiting our web site at Care should be taken that these accessories are properly installed by trained technicians, and that they are used in the manner for which they were designed. SUBSEQUENT OWNER REGISTRATION In the event a vehicle is bought as a used vehicle, we strongly urge the new owner to register the vehicle with Husqvarna. This will enable us to contact you if the need arises. Please send your name, address, and serial number of the vehicle to Husqvarna, 7349 Statesville Rd., Charlotte, NC 28269, Attention: Vehicle Registration. 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 49 Vehicle Specifications VEHICLE SPECIFICATIONS SPECIFICATIONS Electric HUV4210-E Electric HUV4210EXP Gasoline HUV4210-G Gasoline HUV4210GXP POWER SOURCE Drive motor: Direct drive, 48 volts DC, shunt-wound, 3.2 hp • Engine: 4-cycle OHV, 286 cc, 9.5 maximum HP @3600 RPM (per SAE J 1940/1349), single-cylinder, air-cooled, with pressure lubrication system • Engine: 4-cycle OHV, 351cc, 11.5 maximum HP @3600 RPM (per SAE J 1940/ 1349), single-cylinder, air-cooled, with pressure lubrication system • Fuel system: Side-draft carburetor with float bowl, fixed jets, fuel filters, and impulse fuel pump • Governor: Automatic ground-speed sensing, internally geared in unitized transaxle • Ignition: Transistor electronic ignition with electronic RPM limiter • Transaxle: Double reduction helical gear with 12.3:1 direct drive axle • Unitized transaxle: Fully synchronized forward and reverse with neutral and reducedspeed reverse (11.8:1 forward, 17.1:1 reverse) • Torque converter: Automatic, variable-speed, dry type • Electrical system: 48 volts DC, reduced speed reverse • Electrical system: 12 volt, 500 cca at 0 °F (-17.8 °C), 650 at 32 °F (0 °C). 105-minute reserve capacity and 35-amp charging capacity • Batteries: High capacity, deep cycle, Trojan PowerDrive 12-volt, 117 min. capacity • Charger: Automatic, 48-volt; UL and CSA listed • STEERING/SUSPENSION/BRAKES Steering: Self-adjusting rack and pinion • Suspension: Front and rear tapered mono-leaf springs with dual hydraulic shocks • Brakes: Dual rear wheel self-adjusting brakes with cast iron drums and single brakepedal with automatic-release park brake • BODY/CHASSIS Frame/Chassis: Twin I-Beam welded aluminum • Front body: ABS • Rear body: TPO • Tires: 20 x 10.0 – 8 tubeless, 4 ply rated • DIMENSIONS/WEIGHT Overall length 100.2 inches (2545 mm) Overall width 45 inches (1143 mm) Overall height (at steering wheel) 46.9 inches (1191 mm) Wheelbase 66.5 inches (1689 mm) Ground clearance 5.5 inches (140 mm) Front wheel tread 34.5 in (88 cm) Rear wheel tread 38.5 in. (98 cm) Weight (without batteries) 874 lb. (396 kg) 889 lb. (403 kg) Weight (dry, without battery) 781 lb. (354 kg) 805 lb. (365 kg) Vehicle Specifications continued on next page....

Descargar ahora

Introduzca dos números de la imagen: