Votos - 2, Puntuación media: 4 ( )

Fabricar: Nikon Tamaño del archivo: 108.12 kb Nombre del archivo: Idioma del manual:

(moa) 1 click=1/4Moa 1 click=1/4Moa Maximum Internal. *. Adjustment (moa) (Elevation & Windage) 80 50 Parallax Settings (m) at least 45.72-. at least 45.72-. (yds) at least 50-. at least 50-. Outside Diameter of (mm) 43 43 Eyepiece (in) 1.69 1.69 Construction WATER PROOF Nitorogen Gas 5 3. Instructions (1) Battery Your Nikon Monarch X 2.5-10x44 SF Dual Illuminated Reticle is powered by one 3V lithium battery (CR2032 or equivalent). When your reticle grows dim or not light at all, you need to replace the battery. How to replace battery. 1. Hold the rheostat intensity dial tightly and turn the cover with coin counter clockwise. 2. Take out the old battery and put one 3V Lithium Battery into the compartment.Be sure (+) side to be up. 3. Put the cover back and turn it clockwise with coin until the cover in firmly secured. 4. Turn the rheostat intensity dial to the desired color (red or green) and intensity (OFF to 5 : 6 steps). CAUTION: When installing batteries, make sure the firearm is unloaded. Use safe firearm handling practices at all time. 4 *moa = minute of angle : Deviation is 27,8mm at 100m (1in. at 100 yds/25.4mm at 91.44m) 6 (2) Focusing .Look through the eyepiece with your eye positioned about 10cm (4 in) away from the eyepiece lens (Fig. 3-1), and you will see the Nikoplex reticle (Fig. 3-2) or Milliradian Dot reticle (Fig. 3-3). Be sure your eye is positioned within proper alignment and proper eye relief otherwise the view will "black out". .Point the objective end of the scope at the sky (Do not point at the sun) or at a plain unpatterned wall. Loosen the lock ring. (Non-illuminated Reticle model) Turn the eyepiece adjustment counter-clockwise and then turn it clockwise until the reticle appears sharp. (Non-illuminated Reticle model) .Finally, without moving the eyepiece adjustment, turn the eyepiece lock ring as Fig. 3-4 to end so that the eyepiece adjustment will be firmly locked. The lock ring must be firmly tightened to ensure an air-tight seal. 7 Fig. 3-2 Fig. 3-3 Nikoplex Reticle Miliradian Dot Reticle .Lock Ring .Eyepiece Adjustment .Eye ReliefNon illuminated Reticle model .Eyepiece Adjustment .Eye Relief Illuminated Reticle model ... ..Fig. 3-1 Fig. 3-4Lock Ring Eeypiece Adiustment Fig. 3-2 Fig. 3-3 Nikoplex Reticle Miliradian Dot Reticle .Lock Ring .Eyepiece Adjustment .Eye ReliefNon illuminated Reticle model .Eyepiece Adjustment .Eye Relief Illuminated Reticle model ... ..Fig. 3-1 Fig. 3-4Lock Ring Eeypiece Adiustment (3) Magnification .The riflescope 2.5-10x44 SF have a variable magnification from 2.5 to 10x, 4-16x50 SF from 4 to 16x. To change powers. just rotate the power selector ring until the desired magnification appears adjacent to the power index dot. (4) Adjustment and zero setting of the riflescope Sighting through the riflescope, align the rifle with your aiming point on the target and shoot a trial round. If the bullet does not hit the aiming point, adjust the elevation and windage. as follows: .If the bullet hits under the aiming point, turn the elevation adjustment (counter-clockwise) in the direction of the arrow marked "UP" for up as in Fig. 3-5. If the bullet hits high, turn adjustment (clo...

Descargar ahora

Introduzca dos números de la imagen: