Votos - 3, Puntuación media: 3.3 ( )

Fabricar: DeLonghi Tamaño del archivo: 87.96 kb Nombre del archivo: Idioma del manual:

Cabinet Wheels 4. Air Filter Description of the control panel 5. Water Tank 6. Power Cord 7. Continuous Draining Outlet 8. Pump connection (only on some models) Room Display MODE temperature button °F/°C Fan speed button TIMER button button TURBO POWER button PUMP button *Decrease humidity level/ time button Increase humidity level/ time button STAND-BY button ON light Defrost light Tank warning light Pump light * * (only on some models) Control panel Control panel STAND-BY button Press this button to start /stop the appliance. To turn the appliance completely off, remove the plug from the outlet. Room temperature button Press this button to display the Temperature on the LCD display. If you press the button once the display will show the °F . If you press the button twice, the display will show the temperature in °C. After few seconds, the display will automatically show the humidity level. FAN speed button Press this button to select the Fan Speed (High, Medium, Low). Decrease or increase Humidity Level/ Time buttons These buttons are used to adjust the desired humidity level, with 5% increments; they are also used to set the timer. From 0 -10 the hours increase by 30 min. and from 10-24 the hours increase by 1 hour increments. TIMER button With the appliance switched ON, if you press the TIMER button the display will show the hours after which you want the appliance to switch OFF (1-2-3... hours ). With the appliance in the STAND-BY position, if you press the TIMER button the display will show the hours after which you want the appliance to switch ON (1-2-3... hours ). MODE button Press this button to select the Fan only or Dehumidifier modes. TURBO POWER button Use this button to activate the “turbo power” function. In this mode, the appliance will operate at maximum fan speed and in continuous mode. If pressed again, the unit will revert back to previous settings. PUMP button (only on pump models) Use this button to activate the heavy-duty pump system for active drainage. ENGLISH 5 Display lights Display lights ON light When the STAND-BY button is pressed to start the unit, the ON light will come on automatically. The light will go off again when the unit is switched off. NOTE: After a power outage, the unit will not switch itself on again automatically. When the power supply has been reestablished, please press the STAND-BY button to start the unit again. TANK Warning light If the water tank is full, improperly positioned or missing, the tank warning light will start blinking. An alarm will sound until the tank is either emptied or correctly positioned into place. DEFROSTING light With an ambient temperature of less than 15°C, (59°F) the appliance performs defrosting cycles. While the appliance is defrosting, the defrosting light comes on and remains on until defrosting is completed. During the defrosting cycle only the following 4 keys are active: pump button, stand-by button, temperature button, timer button. PUMP light (only on some models) Once the pump button is pressed the pump light will switch on. If the pump light flashes it means that the pump is not functioning properly. Installation Instructions Installation Instructions 1. Allow at least 12 inches (30cm) of space on all sides of the unit for good air circulation. 2. Install your dehumidifier on a floor, table, or shelf. When installing the unit on a table or shelf, make sure the table or shelf is strong enough to support the weight of the unit with a full bucket. Note: The d...

Descargar ahora

Introduzca dos números de la imagen: