Votos - , Puntuación media:
(
)
)
Fabricar: AMX
Tamaño del archivo: 224.01 kb
Nombre del archivo: 0432197.pdf
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
It can dim incandescent lights, cold-cathode, neon and two-wire dimmable ballasts. The module's 120, 240, and 277 VAC ratings are CE, UL, and C-UL approved. Mounting_ points KAI IA "" • AC lighting loads only. • For indoor use only. • This module may require extra power from the AXlink connection or an external power supply connected to the control card. Connecting the RDM-2INC to the AMX Lighting Master Pin 4 (GND) Pin 3 (RLY) Pin 2 (DIM) Pin 1 (+12 V) RDM-2INC four-pin module connector No cot (+) -pin plug from a RDM series module Note: The 4-pin plugs from the module connector to the 4-pin connector on the master (black plug cover facing up). FIG. 2 RDM-2INC connections Lighting Application Drawing (B) Neutral Low-voltage control wiring: 4-pin connectors to AMX Lighting master controller FIG. 1 RDM-2INC RDM-2INC UL and C-UL Ratings • 120 VAC, 50/60 Hz, 2400 W • 240/277 VAC, 50/60 Hz, 2400 W Suggested Dimmed Loads • Incandescent Neutra • Low-voltage Load • Neon, cold-cathode • Two-wire, phase-controlled ballast Specifications • Dimensions (HW): 10.0" x 2.75" (25.4 cm x 6.99 cm) • Phase dependant • Use wires rated at 75°C (167°F) • Torque terminals to 7 in-lbs. (0.8 N/M) • Max. wire size: 10 AWG (4 mm2) • Wire stripping length: 0.28" (7 mm) • Weight: 6.5 lbs. (2.948 kg) • BTU/hr: 600 • Control current: 45 mA @ 12 VDC per dimmer, 90 mA total Caution: Pre-Installation Notes • All Class 1 wiring must be connected to proper terminals. • All control wiring must be connected to proper temrnials. • Disconnect power while installing or connecting the unit. • Keep top and bottom air vents clear at all times. • Test loads for shorts before connecting. • Use low voltage wires with a 300 volt rating or greater. • Use field installed copper conductors. • Run all low-voltage and control wires away from heat producing parts of the dimmer. • Each dimming circuit must have a separate neutral connection. • All electrical ratings are for continuous duty. Two-wire dimmable ballast FIG. 3 RDM-2INC wiring application AMX Corporation reserves the right to alter specifications without notice at any time. For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). 043-019-2197 8/01 ©2001 AMX Corporation. All rights reserved. The AMX logo is a trademark of AMX Corporation. AMX Corporation reserves the right to alter specifications without notice at any time. 3000 research drive, richardson, TX 75082 USA • 469.624.8000 ...