Votos - , Puntuación media:
(
)
)
Fabricar: Panasonic
Tamaño del archivo: 269 kb
Nombre del archivo: GPRV201.PDF
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
Avoid striking or shaking it. The camera could be damaged by improper handling or storage, 3. Keep the face of the camera lens glass clean. Whenever cleaning the camera body, clean the lens glass of the camera by using a soft dry cloth. In case the dirt is hard to wipe off, use a mild detergent and wipe gently. Pay attention to obstacles located at the same height as the rear view camera since they are out of view of the rear view camera Do not operate the camera beyond its temperature range. Do not use the camera in an extreme environment where high temperature or high humidity exist. Use the camera under conditions where temperatures are within -22°F - 140°F{-30°C- +60°C). MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS - 4 - 1 Camera Unit The \/y CCD B/W camera is inside Caution Even though the camera unit is installed in the water-proof housing, do not spray a water jet directly at the camera unit for cleaning purposes 2 Lens The auto iris wide angle lens is installed The focal length is 2 2mm Note Keep the lens glass always clean 3 Camera Angle Adjusting Screws These 4 screws are used to secure the camera unit By changing the fixing position of these screws, the vertical field of view angle of the camera can be changed approx 70° Caméra Cable Connector This connector is a drip-proof type connector and is used to connect the optional camera cable GP-CA40 (33ft/10m) or GP-CA41 (66ft/20m) Caution Whenever disconnecting the camera cable from this connector for maintenance, turn the vehicle's ignition switch to the LOCK position to turn off the power Bracket This bracket is used to secure the camera onto the vehicle INSTALLATION ■ Mounting the camera onto the top of the roof of the vehicle. 1. Remove 4 Camera Angle Adjusting Screws and remove the Camera Unit from the Bracket. 2. Secure the Bracket into the top of the roof by using 4 bolts (obtained locally (6 mm/diameter bolt)). Connect the Optional Camera Cable to the Camera Cable Connector (4). Open the slit on the Connector Cover, and cover the optional Camera Cable and Camera Cable Connector. Note: Set the Connector Cover so that the slit is in the up position. 5. Install the Connector Cover into the chassis of the Bracket. 6. Adjust the camera to the desired angle and fix the Camera Unit into the Bracket using 4 Camera Angle Adjusting Screws. ■ Mounting the camera onto the top of the rear panel of the vehicle. 1. Remove 4 Camera Angle Adjusting Screws and remove the Camera Unit from the Bracket. 2, Secure the Bracket on the top of the rear panel of the vehicle by using 4 bolts (obtained locally (6 mm/diameter bolt)). Connect the Optional Camera Cable to the Camera Cable Connector (4). Open the slit on the Connector Cover, and cover the optional Camera Cable and Camera Cable Connector. Note: Set the Connector Cover so that the slit is in the up position. 5. Install the Connector Cover into the chassis of the Bracket. 6. Fix the Camera Unit into the Bracket using 4 Camera Angle Adjusting Screws. Note When using this camera with the following angle, adjust the camera angle not to touch to the vehicle Change the direction of camera as follows - 9 - VIEW RANGE - 10 ~ SYSTEM CONNECTION MONITOR Reverse Swith (Shift Gear) CAMERA - 11 - TECHNICAL DATA Jj r o 0 n L - 12 - Unit: inch (mm)