Votos - 3, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Intro play You can successively play the first 10 seconds of every track. 1 While stopped, INTRO MODE 2 To cancel Press MODE repeatedly until “INTRO” goes out. Notes: • You can also select Intro play during playback. In this case, Intro play will start from the next track after the current track has finished. • You can also select Intro play during Program play mode. Random play During playback, MODE RND After playing all tracks, the unit stops. To cancel Press MODE until “RND” goes out, or press 7 to stop the disc. Notes: • You can also select Random play in stop mode. • During Program play, you can not select Random play. Program play You can program up to 64 tracks in any desired order including the same tracks. For Audio CD, go to step 3. Though the display differs a little, operation is the same. 1 While stopped, (MP3 only) PROGRAM 00 00 P-01 2 (MP3 only) Select the desired group number. (e.g.02) 02 01 P-01 3 PROGRAM 02 01 P-01 4 Select the desired track. 02 03 P-01 5 PROGRAM PROG 00 00 P-02 The track is registered. 6 For MP3, repeat steps 2-5 to select other tracks. For Audio CD, repeat steps 4 and 5. When you program exceeding 64 tracks, the program sequence number returns to “01” and will overwrite the previous setting. 7 • To confirm the program While stopped, press PROGRAM repeatedly. At this time, you can add and change the program, if required. • To delete the entire program While stopped, press STOP. Or turn off the unit. Program sequence number Track number Repeat play During playback, MODE GROUP ALL To cancel Press MODE repeatedly until the repeat indicator goes out. Notes: • You can also select Repeat play during Program play. • You can also select Repeat play while stopped. Hyper-Bass Sound effect You can enjoy powerful bass sound. OFF 1 2 HBS Anti-Shock Protection EX This function achieves excellent performance against sound interruption caused by vibrations. You will be able to enjoy listening to music during (not vigorous) jogging. By utilizing the high-performance servo circuit, audio data will be stored in the memory ahead of time. For Audio CD: Up to 175 seconds worth (Anti-Shock Protection on/off selectable) For MP3: Up to 426 seconds worth at 128 kbps (Anti-Shock Protection is fixed to on.) Normally, this function is in effect. ASP As the audio data is gradually stored, the indicator changes as follows: ASP ASP To cancel (Audio CD only) A.S.P. / GROUP UP The “ANTI SHOCK” indicator goes out. To activate again (Audio CD only) Press A.S.P./GROUP UP. Notes: • During this operation, the disc rotates at a higher rate than usual in order to collect extra audio data. This may cause the batteries to run out faster and could result in a slight increase in disc rotation noise. • This function can be switched ON and OFF during playback. However, this may cause a slight interruption in the sound because the disc’s rotational speed changes. ANTI SHOCK indicator (Repeatedly) 1 track repeat Other Play Methods (Repeatedly) Power Supply Preparations The illustration of the grip band is omitted. Using dry-cell batteries (not supplied) Caution: Do not forcibly open the battery lid too wide. Battery indicator This indicator appears when the batteries are almost out of power. Power will be cut off a short while later. Note: Turning off the Anti-Shock Protection EX will save the battery power more or less. For details, see “Anti-shock Protection EX” on page 4. (Available for an Audio CD only) Battery indicator AC adaptor Using the AC adaptor (supplied) Notes: • Even if the unit is turned off, small power is consumed as long as the AC adaptor is connected to the AC power outlet. AC power outlet • When the unit is in Hold mode, “HOLd” and “ ” lights as follows. Power on : “ ” stays lit. Power off : “HOLd” and “ ” lights up for a few seconds when 6 is pressed. Note: If the HOLD switch is set to the ON position, you cannot turn on the unit. This function causes the unit to ignore, accidental button presses. Hold mode prevents the following: • Powering on the unit accidentally (which can cause the batteries to go dead). • Play being cut off unexpectedly. To use the Hold mode OFF ON HOLD • To prevent the unit from powering on accidentally, set the HOLD switch to the ON position while the unit is turned off. • To prevent the unit from unexpected operation during play, set the HOLD switch to the ON position after you starts playing the disc. Preventing Accidental Operation (Hold mode) The illustration of the grip band is omitted. Follow the steps in the numerical order. Two “AA” (LR6) alkaline batteries. AC adaptor Before use Make sure the present voltage of your AC adaptor fits to your local voltage before plugging it into the AC power outlet. If it doesn’t, shift the AC line-voltage selector with a screwdriver so that it corresponds to your local voltage. VOLTAGE ADJUSTOR AC 110V ~127V AC 220V ~240V If the power plug will not fit your socket, use the AC plug adaptor. How to use the AC plug adaptor (supplied) Tr...
Otros modelos de este manual:Jugadores - 0504SKMCREORI (439.46 kb)