Votos - 5, Puntuación media: 4.2
(
)
)
|
Resumen del manual
d. The appliance does not appear to operate normally, or exhibits a change in performance. 1 If you experience difficulties in the use of this unit, please check the following before calling for Customer Service. • Noise or distorted sound when playing the radio. o Radio station may not be properly tuned. Tune to desired radio frequency again. o The radio signal is weak. Reposition the unit for better reception. • No radio sound o Radio may not be turned on, Turn the VOLUME/ON/OFF knob clockwise until you hear a click. o Batteries may not be installed. Install four (4) fresh AA batteries in the battery compartment. • CD does not play o The unit may not be set to CD mode. Make sure the mode switch is on CD. o The disc may not be inserted properly. Place the disc in the disc tray with the label side facing up. • CD skips while playing o The disc may be dirty or scratched. Wipe disc with a soft, dry cloth or replace with a new disc. Specifications • Frequency Range o AM: 530kHz – 1710kHz o FM: 88MHz – 108MHz • Power Requirement o DC 9V, 6 C” or UM-2 size batteries (Batteries is not included) 10 SPLASH PROOF AM/FM Radio with CD Player V10M10_IM_EN_08132007 SPLASH PROOF AM/FM Radio with CD Player V10M10_IM_EN_08132007 OPERATIONAL INSTRUCTIONS USER SAFETY GUIDE Tips for Getting Better Reception 1. This unit has the built-in AM/ FM antennas. Thus, an external FM wire antenna isn’t required to be installed on this unit to receive the FM radio. However, if you reside in the poor reception area and want to enhance the FM radio reception more, you might attach the pigtail wire antenna at the external FM antenna terminal located on the back of the unit. 2. To get better AM radio reception, be sure to place the unit horizontally and reposition it if there are noises on the AM station. Cleaning the Unit 1. To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning. 2. The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use caution when cleaning and wiping the plastic parts. 3. If the cabinets become dusty, wipe them with a soft dry dust cloth. Do not use any wax or polish sprays on the cabinets. 4. If the front panel becomes dirty or smudged with fingerprints, it may be cleaned with a soft cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or polishes as these will damage the finish of your unit. Caution: never allow any water or other liquids to get inside the unit while cleaning. Cleaning the Disc 1. Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact with the shiny, unprinted side of the disc. 2. Do not attach adhesive tape, stickers etc., to the disc label. 3. Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive cleaners to clean the disc. If necessary, use a CD cleaning kit. 4. If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched). 5. When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the disc. Never wipe in circular motions. 6. To remove a disc from its storage case, press down on the centre of the case and lift the disc outs, holding it carefully by the edges. 7. Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft cloth. Unlike conventional records. compact disc have no groove to collect dust and microscopic debris, so gently wiping with a soft cloth should remove most particles. Note: Do not use solvents such as benzine thinner, commercially available cleaners or anti-static spray intended for analogue discs. 9 IMPORTANT SAFETY INSTRUCTIONS – CONTINUED 11. SERVICING - The user should not attempt to service the appliance beyond that described in the user's operating instructions. All other servicing should be referred to qualified service professional. 12. BATTERY USAGE – To prevent battery leakage, which may result in bodily injury, property damage or damage to the unit, follow these instructions: a. Install all batteries correctly according to the polarity (+ - ) as marked on the unit. b. Do not mix old and new batteries, carbon and alkaline, etc. c. Remove batteries from the unit when the device will not be used for an extended period of time. 13. LEAD AND MERCURY - This product may contain lead and/ or mercury. Disposal of these materials may be regulated by your local authorities due to environmental considerations. For more detailed disposal or recycling information, please contact your local authorities or the EIA (Electronic Industries Alliance) – eiae. org IMPORTANT NOTES 1. Do not attempt to clean the unit with chemical solvents as this might damage the finish. Use a clean, dry cloth. 2. Keep this manual in a safe place for future reference. You can help to protect the environment! Please remember to respect the local regulations: Hand in the non- wor...