Votos - 4, Puntuación media: 3.8
(
)
)
|
Resumen del manual
Otherwise, your oven will not operate ■In models with grill; Keep the oven door closed during grilling. If the oven door is accidentally opened when you are using the grill, your appliance will be damaged (*) and you will invalidate your guarantee. (*) If the oven door is opened, the surfaces of the appliance will get very hot resulting in heat damage to the door, the control panel, knobs and side panels. □ * Always use oven gloves while removing the grill rack and dishes when in use. * During operation of this appliance the door and outer surfaces will get hot. Take care not to touch hot surfaces during use *The surfaces of the inox model appliances which are nearer to the burners may change colour because of the excessive heat in the course of time. *limmediately switch off the appliance from the mains if a crack is detected on the ceramic glass surface. * Always switch off the appliance from the mains when the appliance is not in use. before cleaning or in the unlikely event of a product failure becoming apparent. *Before your appliance is connected to the gas supply, check the ensure that the gas category and pressure specifications shown in the data plate corresponds with your gas supply. If necessary call authorized service for adjusting to gas category. * Please change the plastics hose just before its changing time as stoted. 2 Part 2: Important Installation and preparation of your oven • Before your appliance is connected to the mains electricity supply, check, to ensure that the voltage and the "frequency shown in the data plate corresponds with your power supply. The data plate is situated back cover of the oven, or it is situated in the front of the storage compartment and can be seen by opening the storage compartment cover or pulling the drawer. Warning! This appliance must be earthed Our company shall not held responsible for any damage caused by the utilisation of the oven without ground socket. • Before applying to Authorized service, have the electrical wiring of your home ready for connection. If the appliances is connected by a plug, that the plug is easily accessible after installation (but not above the hob) •■This product must only be installed by a qualified electrician eg. local electricity company to a suitable double pole control unit with a minimum contact clearance of 3 mm in all poles which should be adjacent to (but not above) the cooker in accordance with IEE regulation. Failure to observe this instruction may result in operational problems and invalidation of the product warranty. If the appliance is connected by a plug, that the plug is easily accessible after installation (but not above the hob). The cable length should be 2 mt max for isolation safety. In models with "small type- terminal block" In mix models a cable supplied with a plug with your oven (H05VV-F 3G 1.5 mm2) • If a cable without a plug is provided together with your oven (H05 V V-F 3G 2,5 mm2 ) Take care to connect as below: Brown cable = L (Live) Blue cable = IM (Neutral) Green/Yellow cable = E (Earth ) • If your oven is supplied without supply cord use schema-i to choose supply cord and use schema-11 for installation of cord. The cable length should be max 2m long for isolation safety. •■Open the terminal block cover. •-Connect the supply cable according to wiring diagram on the rear cover. • Fix the supply cable to main body with integrated screw via cable tightener. • Assembly the terminal block cover to its place. Your oven is suitable for single and three phase connection. •The mains cable must pass through the cable damp. •The mains cable should be routed away from the appliance and in particular ventilation slots, the vent outlet and should not be obstructed when pushed in to position between the appliance and the wall and/or cabinet. E—(©1 W-13 rT h hL'E_© 3 №û swwowis v Schema II Connection Type Monophase Three phase with Neutral Two phase with Neutral Voltage 220/230/ 240 V 380/400/41 5 V 380/400/ 415 V Supply cord type (max 2m long) 3x4.0 mm2 H05 VV-F 5x2,5 mm2 H05 V V-F 4x2,5 mmL H05 V V-F 3 In models with " covered terminal block" In mix models a cable supplied with a plug with your oven (H05 V V-F 3G 1.5 mm2) »•If a cable without a plug is provided together with your oven (H05 V V-F 3G 2,5 mm2 ) Take care to connect as below: Brown cable = L (Live) Blue cable = IM (Neutral) Green/Yellow cable = E (Earth) •w If your oven is supplied without supply cord use schema-1 to choose supply cord and use schema-ll for installation of cord. The cable length should be max 2m long for isolation safety. Open the terminal block cover (1). Connect the supply cable according to wiring diagram on the rear cover. •••Assembly the terminal block cover to its place. *■ The mains cable must pass through the cable clamp (2). *■ Fix the supply cable to main body with two screw via cable tightener (2). Your oven is suitable for single and three phase connec...
Otros modelos de este manual:Placa - CE 61210 (1.28 mb)
Placa - CE 68100 (1.28 mb)
Placa - CM 68201 (1.28 mb)
Placa - CM 68201 C (1.28 mb)