Votos - 4, Puntuación media: 4.3
(
)
)
|
Resumen del manual
Never remove hose from bottle near ignition sources, while stove is lit, or hot to touch. DANGER • EXPLOSION - FIRE HAZARD • Always attach or detach fuel canisters source outdoors; never while stove is lighted, near flame, pilot lights, other ignition sources or while stove is hot to touch. • This stove is very hot during use and can ignite flammables too close to the burners. Keep flammables at least 24 inches from the sides and 48 inches from the top of the stove. Keep gasoline and other flammable liquids and vapors well away from stove. • The stove must not be exposed to flammable vapors or liquids during lighting. 12 12 Using the Reflector Disc and Windscreens CAUTION Always place the stove on the reflector disc during setup and use. The disc must be used to help protect combustible surfaces from excess heat and cooking splatter. ¦ Always place the stove on the reflector disc during setup and use. ¦ To improve stove performance in windy conditions, unfold the windscreens and place them around the stove. Fold the ends together. Place the windscreens so that the notched ends are down and allow access to the flame adjusters (Fig. 34). ¦ Roll or gently fold the windscreens for storage. FIG. 34 English-12 13 13 To Store ¦ Make sure stove is cool. ¦ Move stove away from flame (including pilot lights) and other ignition sources. ¦ Disconnect the fuel hose at the threaded fitting attached to the fuel bottle. ¦ If some liquid fuel remains in the fuel hose, drain the excess fuel before placing the stove in your backpack or storage container. ¦ Replace the protective caps onto the threaded fittings. ¦ The stove may be folded for compact storage (Fig. 35). The hose remains attached to the stove. FIG. 35 • MAINTENANCE • Keep stove area clear and free from combustible materials, gasoline and other flammable vapors and liquids. • Do not obstruct the flow of combustion and ventilation air. • A good flame should be blue with minimal yellow tip. Some yellow tips on flames are acceptable as long as no carbon or soot deposits appear. • Wipe clean with soft cloth and mild dish detergent. Do not use abrasives. English-13 14 14 Troubleshooting Symptom Problem Solution Burner will not light or flame self- extinguished. The fuel pump is shipped from the factory dry of fuel or the stove has been in extended storage. Read and follow the section titled “Initial Fueling of Dry Pump” (see page 8). Burner will not light or flame self- extinguished. Fuel bottle empty. Refill fuel bottle 2/3 full with clean and fresh Coleman® fuel or unleaded fuel. Burner will not light or flame is low or flame self- extinguished. Little or no pressure in fuel bottle. Check connections for leaks and pump 40 strokes. Yellow flame. Excess fuel in burner. A yellow flame is normal until the generator warms up. If yellow flame persists, turn off stove, allow flame to self-extinguish and the stove to cool. If necessary, invert stove to remove excess liquid fuel from the burner. Follow lighting instructions. Low heat. Generator tip plugged. Turn flame adjuster back and forth several times to clean generator tip. Be sure to use only fresh and clean fuel. Low heat. Faulty generator. Replace with a new generator. This is a normal periodic maintenance procedure. The generator life is dependent on the type of fuel used. Generator life is extended by using clean Coleman® fuel. Persistent small yellow flame. Faulty generator. Replace with a new generator. Persistent high yellow flame. Failure in the fuel delivery system. May need to replace pump assembly. Please contact Consumer Service (see page 17). Intermittent short blue flame and rapid loss of pressure. Failure in the fuel delivery system. May need to replace pump assembly. Please contact Consumer Service (see page 17). Yellow smokey flame. Spider webs, insects, or other obstruction in the burner and air tube. Remove burner to inspect and clean the burner and air tube. Pump does not pressurize the liquid fuel canister. Pump seals are dry or worn. Squirt a few drops of oil in the OIL HOLE in the pump cap. This will keep the pump functioning properly (Fig. 36). If this does not correct the problem, replace the pump seals or purchase a new pump assembly. Intermittent yellow flame. Stove has been operated for an extended period of time at a low heat setting. Adjust the flame to a higher setting with the FLAME ADJUSTER. English-14 Replacement Parts List 4 Item Part No. Description 1 9770-5051 Plunger Assembly 2 9770-5551 Pump and Valve Assembly 3 R9760-501 Stove Maintenance Kit (includes one item on the next page) 4 9770-5611 Service Parts Kit (includes several items on the next page) 5 9780-5081 Fuel Bottle Assembly (22 fl. oz. capacity) 4 English-15 3 3 4 4 4 2 1 4 5 “O” Ring “O” Ring 4 “O” Ring “O” Ring * This Stove Maintenance Kit includes only one generator. Purchase two Stove Maintenance Kits to service both burners. * Replacement Parts List 6 Item Part No. Description 6 9780-5271 Burner Assembly Complete w/ H...