Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
The view through the appliance door is not impaired by this. When the appliance door is open this coating can have the effect of a light- coloured film. This is part of the design and is not due to any quality defect. Hob Your hob comes with its own instructions for use. They contain information on care and cleaning. Cleaning the cooking compartment Caution! Risk of damaging the surface. Do not clean the appliance while still warm, even if using oven cleaners specially intended for this purpose. Notes ¦ Enamel is baked on at very high temperatures during manufacture. This can cause some slight colour variations. This is normal and does not affect proper functioning. ¦ The edges of thin trays cannot be completely enamelled. As a result, these edges can be rough. Anti-corrosion protection is still guaranteed, however. Appliance part Cleaning agent/ aid Enamel surfaces To facilitate cleaning, you can switch on the interior lighting and detach the appliance door if necessary. Apply commercially available washing- up liquid or a vinegar solution with a soft, damp cloth or chamois; dry with a soft cloth. Loosen baked- on food residues with a damp cloth and detergent. We recommend using oven cleaner if the oven is very dirty. When cleaning using an oven cleaner, check the manufacturer's instructions. Leave the cooking compartment open to dry after cleaning. Door seal Hot soapy water Hook-in rack/ telescopic shelf Hot soapy water Accessories Soak in hot soapy water, clean with a brush and sponge or wash in the dishwasher. Keeping the appliance clean To avoid getting the cooking compartment dirty, ¦ clean the cooking compartment after each use, as dirt will bake on the next time it is heated up, and this can only be removed with difficulty ¦ always remove flecks of limescale, grease, starch and albumin (e. g. egg white) immediately ¦ use 3 CircoTherm ® whenever possible. This operating mode creates less dirt ¦ Use the universal pan to bake very moist cakes ¦ use suitable ovenware when roasting (e.g. roasting dish) or a roasting sheet (see section: Accessories) Removing and fitting the appliance door You can remove the appliance door to clean it more thoroughly. : Risk of injury! The hinges of the appliance door may snap shut with great force. Always open the hinge locking lever fully when removing the appliance door and close it fully after refitting. Do not reach into the hinge. : Risk of injury! If the appliance door has only been unhinged on one side, do not reach into the hinge. The hinge can snap back with great force. Call the aftersales service. Removing the appliance door 1. Open the appliance door fully. 2. Open the locking levers on the left and right- hand side fully. The hinges are secured and cannot snap closed. 3. Close the appliance door until resistance becomes noticeable ( figure A) 4. With both hands, grip the door on the left and right- hand side, close the door a little more and pull it out (figure B) . : Risk of injury! The appliance must not be used again until the door panels and appliance door have been correctly fitted. Removing the door panel Note: Before removing, make a note of which way round the door panel is fitted, so that it is not refitted the wrong way round. 1. Unhook the appliance door and lay it on a soft, clean surface with the front side facing downwards ( see section: Removing and installing the appliance door). 2. Pull off the cover at the top of the appliance door. Press in the tabs on the left and right using your fingers ( fig.A) . 3. Lift the door panel slightly and pull it out (Fig. B). Removing the intermediate panel Lift the intermediate panel slightly and pull it out towards you. Fitting the appliance door 1. Insert the hinges in the left and right- hand holders (figure C). The notch on both hinges must engage. 2. Open the appliance door fully. 3. Close the locking levers on the left and right-hand side fully (figure D). The appliance door is secured and can no longer be removed. 4. Close the appliance door. Cleaning the door panels To facilitate cleaning, you can remove the inner door panels from the appliance door. : Risk of injury! The components inside the appliance door may have sharp edges. Take care not to cut yourself. Wear protective gloves. Cleaning Clean the door panel with glass cleaner and a soft cloth. : Risk of injury! Scratched glass in the appliance door may develop into a crack. Do not use a glass scraper, or sharp or abrasive cleaning aids or detergents. Fitting the intermediate panel Note: During installation, make sure that the lettering "top right" is upside down at the bottom left. Insert the intermediate panel towards the back as far as it will go. Fitting the door panel 1. Insert the door panel at an angle towards the back into both brackets as far as it will go. The smooth surface must face outwards. 2. Put the cover back in place and press on it until it clicks in place. 3. Refit the appliance door. Cleaning the hook-in racks You can r...