Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
Defective control lamp. Replacement only by an authorised expert. 81 Problem Possible cause Remedy . . . if smoke is generated during Roasting temperature roasting or grilling? to high. Wire shelf or universal Place wire shelf into universal pan and pan slid in incorrectly. insert together in shelf position. . . . if enamelled slide-in parts Normal occurrence due Not available. show mat bright stains? to dripping meat juices. . . . if the glass pane or window Normal occurrence, due Switch on the oven for app. of the oven door become to existing temperature 5 minutes at 100° C. clouded? difference. . . . if the oven shows increasing Normal occurrence, Briefly open the oven door occasionally condensation water? e.g. in the case of cakes during baking or roasting, wipe up the with very moist topping condensation water after operation. (fruit) or roasts. . . . if the panes of the oven Normal soiling. Remove the oven door and place it door are dirty on the inside after facing down on a clean and soft some time of use? surface. Grip the door glass next to the hinges, pull the upward and remove it. Press in the retaining clip with your thumb on one side and disengage the inner door glass e.g. with the spatula, then repeat on the other side. Installation after cleaning: Insert inner door glass into the holder. First engage the right side and then the other side. Hang door glass and press down next to the hinges until it clicks into place. Assembly Instructions For the installer and kitchen expert! Important installation Properly dispose of packaging materials. notes Do not use oven door handle for transporting or handling the unit during installation. WARNING: Connection and first start of the appliance may only be performed by an authorised specialist. Connection must be made using an H05RR-F 3x1, 5 9 mains connection cable. Rated consumption, rated voltage and type no. of the appliance: See appliance nameplate behind the oven door to the left beneath the side edge of the oven. The unit's nameplate is located at on the sidewall of the unit. Electrical safety of the appliance can be ensured only if the equipment earth in the building installation has been installed according to regulations. In the case of repairs interrupt all power connections to the unit. Connectable built-in hobs HSE-6PA4030 HSE-6PA3W30 HSE-6PL4030 The properly installed appliance must be covered on all sides in such a fashion that not even components with rough insulation are exposed to the touch. The cover must be removable with tools only. Furniture programmes Cooker conversion cabinets from Installation of the hob WARNING 560 490100 100 30-50 585 550mind. mind. 560 15 virtually all lines of kitchen furniture are suitable for installing the built-in cooker. However, the veneers or plastic laminates on the conversion cabinets must be applied with heat-resistant cement (90 C). If plastic laminates or cement are not sufficiently heat- resistant, warping, bubbling or detachment of the finish may result. The appliance may be installed with a high cabinet or a high wall on...
Otros modelos de este manual:Placa - E3422B0/03 (2.86 mb)
Placa - E3422B0/10 (2.86 mb)
Placa - E3422N0/01 (2.86 mb)
Placa - E3422N0/03 (2.86 mb)