Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
4 2 YOUR RADIO AT-A-GLANCE ................................................... 5 3 INITIAL SETUP ....................................................................... 6 4 SUPPLYING POWER AND USING EXTERNAL ANTENNAS ......... 7 5 GENERAL RADIO OPERATION.................................................. 8 6 SHORTWAVE RADIO OPERATION ........................................... 11 7 STORING STATIONS INTO MEMORY ....................................... 13 8 USING THE CLOCK, ALARM, AND SLEEP TIMER FEATURES ..... 14 9 MORE INFORMATION ABOUT SHORTWAVE ............................ 16 10 GETTING STARTED WITH SINGLE SIDEBAND (SSB); MARITIME & AERONAUTICAL WEATHER AND COMMUNICATION FREQUENCIES; HAM RADIO COMMUNICATION FREQUENCIES; TIME SIGNALS................... 24 11 TECHNICAL INFORMATION .................................................... 31 12 INDEX TO THE RADIO’S CONTROLS ....................................... 32 13 SERVICE INFORMATION ......................................................... 33 14 ONE YEAR LIMITED WARRANTY ............................................. 34 23 G4000AOPERATIONMANUALG4000AOPERATIONMANUAL 1 QUICK SETUP BUT PLEASE READ THE REST OF THE MANUAL LATER! 1. Insert batteries or connect the included AC adaptor. 2. Set the DX/LOCAL switch to DX (left side of radio). 3. Turn the SSB switch OFF (right side of radio). 4. Fully extend the telescopic antenna. 5. With the radio off, press and release the AM button once. 6. Immediately press and release the STEP button. “10KHz” now appears in the right side of the display, and will disappear in a few seconds. (See page 6 for more information about this procedure.) 7. Turn the radio on by pressing the ON/OFF button. 2 YOUR RADIO AT-A-GLANCE WHAT’S INCLUDED WITH THE G4000A? • Owner’s Manual • Warranty card • A Grundig AC adaptor for use on 110-120 VAC outlets in the Americas • A 23 foot “reel” antenna for shortwave reception • Earphones 54 G4000AOPERATIONMANUALG4000AOPERATIONMANUAL 3 INITIAL SETUP I M P O RTA N T ! S E T U P F O R N O RT H A D D I T I O N A L S E T U P A M E R I C A N U S E I N F O R M AT I O N If you do not live in the United States or 1. On the right side of the radio, set the SSB switch Canada, the radio is set up at the factory for to the OFF position. This feature is described on the 9 kilohertz spacing used for your AM page 24. NOTE: the FINE TUNING control, on (MW) stations. This part of the initial setup the right side of the radio, is only activated and can be ignored. needed when the G4000A is in the SSB mode. You do not need to use this control when listening North America’s AM stations are exactly 10 kilohertz to regular AM, FM, and shortwave broadcasts. apart. At the factory, the radio is set up for the 9 kilohertz spacing of stations in Europe. To change On the left side of the radio, set the DX/LOCAL this to the 10KHZ spacing: switch to the DX position. DX allows for maximum sensitivity, the preferred position. 1. With the radio OFF, press and release the AM button once. 2. Immediately press and release the STEP button. “10 KHz” now appears in the right side of the display and will disappear in a few seconds. This change will be permanently in the radio’s memory as long as batteries are not taken out for a period of ten minutes or more. When traveling outside of the Americas, use the same procedure as above to set the spacing back to 9 kilohertz. 4 SUPPLYING POWER AND USING EXTERNAL ANTENNAS HOW TO INSTALL BATTERIES Install six AA alkaline batteries. Follow the diagram imprinted on the back of the radio near the battery compartment. With the radio face down and the battery compartment toward you: • The flat ends (-) of the bottom batteries go toward the left. • The flat ends (-) of the top batteries go toward the right. AC ADAPTOR USE The Grundig adaptor supplied with this product is only for use in the Americas, where household AC voltage is 110-120 volts AC. Do not use this adap- tor in countries with household AC voltage of 220- 240 volts AC. USING YOUR GRUNDIG AC ADAPTOR 1. Plug the adaptor into a household outlet. 2. Insert plug into the radio’s DC 9 V socket. NOTE: when using the adaptor, it is OK to leave batteries in the radio. HOW TO USE THE INCLUDED “REEL” ANTENNA AND THE EXTERNAL ANTENNA SOCKET (left side of the radio) The SW EXT. ANT. Socket is for shortwave antennas. Use it with the included “reel” antenna. Always fully unroll the “reel” antenna and place it as high off the floor as possible, next to the windows. PROFESSIONALLY ENGINEERED ANTENNAS Professionally engineered, outdoor shortwave antennas, available through specialized retailers, can also be used. Use the SW. EXT. ANT. Socket mentioned above. The socket is a 1/8 inch mono socket, used in conjunction with a 1/8 inch mono plug, such as the plugs often used for mono ear- phones. If you would like advice about shortwave antennas, please call Eton technical support at 1-800-872-2228 for U.S. and 1-800-637-1648 for Canada. 76 G4000AOPERATIONMANUALG4000...