Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
Failure to obey this warning could result in death or serious injury. 7 BACKHOE OPERATION SAFETY FIRST!! READ AND UNDERSTAND THE SAFETY INSTRUCTIONS (pages 2-5 of this manual) BEFORE BEGINNING ANY BACKHOE OPERATION DANGER Failure to obey the following procedures will result in death or serious injury. .. Avoid contacting overhead wires and underground pipes or cables. Failure to heed may result in electrocution or explosion. WARNING Failure to obey the following procedures could result in death or serious injury. Never lift this product: .. above the operator’s eye level OR .. to a height where visibility is obstructed, whichever is lower. Use caution when raising loaded bucket. Objects could fall from bucket toward bystanders or operator. NOTICE USE OF REAR COUNTERWEIGHTS IS REQUIRED! Refer to your power unit’s operator’s manual for safe operating limit and use of counterweights. TO DIG: 1. Be sure the loader is on solid ground before digging or lifting any load. 2. With the loader arms partially raised and the bucket cylinder partially extended, slowly curl the dipperstick toward the loader (using the loader’s tilt control). The loader arms may need to be lowered or raised and/or the bucket cylinder extended to allow the bucket to penetrate the soil. 3. As the bucket fills, extend the bucket cylinder and extend the dipper or raise the loader arms to lift the bucket clear of the hole. 4. The depth of the hole will be controlled by the amount the dipper is extended and the height of the loader arms. .. Use extreme care when working on hillsides. Always dump loaded bucket on uphill side of backhoe to minimize possibility of upset. .. Exercise caution when working close to fences, ditches, or on uneven ground. DO NOT: .. Dig close to the loader’s wheels or under the loader; this could cause a cave-in and vehicle overturn. TO DUMP ON GROUND: 1. With the bucket raised clear of the hole, slowly back up and pivot the loader rearward about the front wheels. This will swing the loader away from the trench, and the bucket to the side to dump. .. Keep loads close to the ground while transporting. 8 BACKHOE OPERATION (continued) SAFETY FIRST!! READ AND UNDERSTAND THE SAFETY INSTRUCTIONS (pages 2-5 of this manual) BEFORE BEGINNING ANY BACKHOE OPERATION DANGER Failure to obey the following procedures will result in death or serious injury. .. Avoid contacting overhead wires and underground pipes or cables. Failure to heed may result in electrocution or explosion. WARNING Failure to obey the following procedures could result in death or serious injury. Never lift this product: .. above the operator’s eye level OR .. to a height where visibility is obstructed, whichever is lower. Use caution when raising loaded bucket. Objects could fall from bucket toward bystanders or operator. TO CUT A SHALLOW TRENCH 1. With the loader arms partially raised and the bucket cylinder partially extended, slowly curl the dipperstick toward the loader (using the loader’s tilt control). The loader arms may need to be lowered or raised to allow the bucket to penetrate the soil. 2. When the bucket is positioned at the desired depth, slowly back up the loader, keeping the bucket height constant to cut a shallow amount of soil. IMPORTANT The tilt circuit of your power unit must be protected with a port relief; ignoring this precaution CAN result in damage to your power unit and/or this product and WILL void all FFC warranties WARNING Always back away from trenches before turning. Failure to obey this warning could result in death or serious injury. TO FILL A TRENCH 1. With the loader arms partially raised, curl the dipperstick (attachment mainframe) forward with the bucket cylinder extended and the bottom of the bucket flat on the ground. The entire height of the bucket should be visible. 2. Use the loader’s tilt cylinder only to raise the bucket above the material pile. 3. Pivot the loader to reach over the pile and tilt the backhoe downward so the bottom of the bucket is approximately 12” below the top of the pile. 4. Pivot the loader toward the trench, using the side of the bucket to move the material into the trench. Repeat this process, lowering the bucket 6” at a time. 5. Move your power unit forward and repeat the above steps to continue filling the trench. IMPORTANT Make sure the portion of the trench to be driven on is full before moving forward. Moving on an unstable surface CAN result in damage to your power unit and/or this product and WILL void all FFC warranties .. Always lower the bucket to the ground, set the parking brake, stop engine, remove ignition key and wait for all moving parts to stop before leaving the operator’s seat. 9 BACKHOE MAINTENANCE SAFETY FIRST!! READ AND UNDERSTAND THE SAFETY INSTRUCTIONS (pages 2-5 of this manual) BEFORE BEGINNING ANY BACKHOE MAINTENANCE BEFORE FIRST USE .. Inspect the attachment for shipping damage. If damage does exist, do not operate until the damaged parts have been replaced or repaired. B...
Otros modelos de este manual:Cargadoras - LAF2301 (605.96 kb)