Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
The drain hose loop must be at least 32” high from the floor to insure proper drainage. Electric Shock Hazard Grounding Instructions: The dishwasher must be connected to a grounded metal, permanent wiring system or an equipment-grounding conductor must be run with the circuit conductors and connected to the appliance’s equipment grounding terminal or lead. It is the consumer’s responsibility to contact a qualified installer to make sure the electrical installation conforms with the National Electrical Code and local codes and ordinances. Do not connect the dishwasher to the power supply until the appliance is permanently grounded. All wiring connections must be enclosed in the junction box. This unit has copper lead wires. Joining aluminum building wire to stranded copper wire should be done by a qualified electrician using materials recognized by UL and local codes. Do not use an extension cord. Such use can result in fire, electrical shock, or other personal injury. Failure to follow these instructions could result in death or serious injury. 7 2. Route water line to water inlet valve as shown in Figure 4. 3. While firmly pulling water supply line into 90° elbow, tightly connect water supply to water inlet valve. Supply line must be free of kinks, scales, chips, and lubricants. 4. Turn on water supply and check for leaks. Finishing the Water and Electrical Connection 6 Property Damage Do not solder within 6” of the water inlet valve. Damage to the plastic parts in the valve may occur. Use care that no sealer, dirt, or other objects enter the valve. Damage to the filter screen may occur. Be sure the dishwasher is placed where the water inlet valve will be kept from freezing. If the valve freezes, it may rupture and flooding may occur. Water Line 1. Flush water line before connecting it to water inlet valve to prevent early clogging of filter screen. Place a bunched towel over end of line to prevent splashing. Open water supply valve for a few seconds and let water drain into a pan. Turn off water supply at shut-off valve. Electrical Supply 1. Remove junction box cover and pull house wiring into junction box. See Figures Below. 2. Use a UL listed conduit connector (not included) at box to stabilize wiring. 3. Connect incoming black lead to dishwasher’s black lead, incoming white lead to dishwasher’s white lead and incoming green lead to dishwasher’s green lead with wire nuts. (See Grounding Instruction Warning). Wire nuts must be tight. . Make sure that all tape is removed from the Silverware Baskets. The drain hose loop must be at least 32” high from the floor to insure proper drainage. Cut for 5/8” connection. Figure 9(a) Cut for 3/4” connection. Larger end of hose fits disposer inlet fitting. Drain Hose JUNCTION BOX COVER . 4. Replace junction box cover. GREEN WIRE TO GREEN WIRE (GROUND) WHITE WIRE TO WHITE WIRE (NEUTRAL) BLACK WIRE TO BLACK WIRE (HOT) Figures 6a check these items: . Water and electrical lines are hooked up to dishwasher. . All four leg levelers are positioned properly. . Cabinet Seals are positioned on the sides and top of the dishwasher. . Cabinet Attachment Clips are attached to the cabinet or countertop and kickplate brace. . Replace Toe an...
Otros modelos de este manual:Lavavajillas - 685000800012 (427.04 kb)
Lavavajillas - 685000800012 (427.04 kb)
Lavavajillas - 685000800012 (427.04 kb)
Lavavajillas - 685000800012 (427.04 kb)