Votos - , Puntuación media:
(
)
)
Fabricar: Frigidaire
Tamaño del archivo: 443.93 kb
Nombre del archivo: 637a253f-53c2-1cf4-65d0-d16af4bf63b8.pdf
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Resumen del manual
Sanitize Option (available on select models) To sanitize your dishes and glassware, select the SANITIZE option. When selected, the light above the pad will come on and remain on until end of cycle. The water temperature in the final rinse will be raised to 155°F (68°C) and will maintain that temperature for 9 minutes. This option is available in POTS & PANS,NORMAL WASH and ECO WASH. Only these sanitization cycles have been designed to meet NSF requirements. The cycle time will be extended until the proper water temperature is reached. Washing action will continue during the water heating delay. For best results, the incoming water temperature should be at least 120°F (49°C). The sanitize criteria may not be satisfied if there is an interruption of the cycle, power failure or if the incoming water temperature is below 120°F (49°C). To turn off the SANITIZE option, press the pad a second time. The light above the pad will turn off. Heated Dry The HEATED DRY option in combination with rinse aid will enhance drying performance. HEATED DRY option is available on all cycles except ECO WASH & RINSE ONLY. Be sure nothing protrudes through bottom of basket or rack to block the spray arm. Dishwasher Dispenser & Detergents Filling the Detergent Dispenser The detergent dispenser has one main wash and one pre wash cup. The covered cups open automatically to release detergent. • Use only fresh automatic dishwashing detergent. Other detergents will cause oversudsing. • When using automatic dishwashing detergent tabs, place one tab in main wash cup and close. • Add detergent just before starting cycle. • Store detergent in a cool,dry location. Moist or caked detergent will not dissolve properly. The use of industrial grade detergent can damage the heating coil and other parts of the dishwasher leading to damage to the unit and surrounding property. Use only household grade automatic dishwasher detergents. How much Detergent to use The amount of detergent to use depends on the water hardness. Water hardness is measured in grains per gallon. Using too little detergent can result in poor cleaning and hard water filming or spotting. Using too much detergent in soft water can cause a permanent film called etching. Your local water company, water softener company or county extension agent can tell you the water hardness in your area. Cover Main Wash Cup Cover Latch Pre Wash Cup Note: If the cover is closed on the Main Wash Cup, open by pressing the cover latch. Rinse Aid Rinse aid greatly improves drying and reduceswater spots and filming. Water "sheets" off dishes rather than forming water droplets that clingand leave spots. A dispenser, located next to the detergent cup, automatically releases a measured amount ofrinse aid during the last rinse. If spotting and poordrying are problems, increase the amount of rinseaid dispensed by rotating the dial to a highernumber. The dial is located under the dispensercap. The indicator will be dark when full and willshow clear when it is time to refill. To add liquid rinse aid, turn dispenser cap 1/4 turncounterclockwise and lift out. Pour in rinse aid until liquid touches the indicated fill level. Replace cap. Do not overfill since this can cause oversudsing. Wipe up any spills with a damp cloth. The dispenser holds enough for 35 to 140 washes, depending on setting. Dispenser Opening Indicator Adjustable settingDispenser Cap MoreLess 6 Care and Cleaning Allow heating element to cool before cleaning the interior. Failure to do so can result in burns. Burn Hazard Outside—Occasionally wipe with a mild nonabrasive detergent and water. Rinse and dry. Models with Easy Care Real Stainless Finish —Clean outer door with warm soapy water and a dishcloth or sponge. Rinse with clean water and a dry cloth. Do not use harsh cleaners. Inside—The inside of the dishwasher is self- cleaning with normal use. If needed, clean around the tub gasket area with a damp cloth. The filter is self- cleaning. A glass trap located in the center of the filter is designed to collect pieces of broken glass, straws, bones and pits. To remove items in glass trap, grasp handle, lift out, empty and replace. Note: Hard water may cause lime deposit buildup on the interior of the dishwasher. Overfill Protector—keeps dishwasher from overfilling and is located in the left front corner of the tub. • Clean occasionally with household cleaner containing vinegar or bleach to dissolve any buildup. • Overfill Protector should move up and down freely about one inch. If it does not move, lift and clean underneath. Care of Drain Air Gap If a drain air gap was installed for your built-in dishwasher, check to make sure it is clean so the dishwasher will drain properly. A drain air gap is usually mounted on countertop and can be inspected by removing the cover. This is not part of your dishwasher and is not covered by warranty. Property Damage Hazard Freezing temperatures may cause water lines to rupture. Be sure all supply lines to and circ...