Votos - 0, Puntuación media: 0 ( )

Fabricar: Bosch Tamaño del archivo: 1.76 mb Nombre del archivo: Idioma del manual:

Therefore: Remove the mains plug, cut the mains wire and set aside. Damage the door lock so that the door can no longer be closed. Before using for the first time The appliance was checked before it left the works. In order to remove possible water test remains, use the appliance for the first time without any dishes, using the highest temperature. Also fill salt, rinse aid and detergent in the filling compartments. Getting to know your dishwasher Illustrations of the control panel and the interior of the dishwasher are shown on the rear fold-out cover of this manual. Fold this page out before you read the manual. Control panel 1 Programme selector 2 Start positions for the individual programmes 3 Door opener 4 Main switch (ON/OFF) 5 Programme overview Appliance interior 20 21 Top basket Additional cutlery basket for the top basket * 22 23 24 25 26 27 Top spray arm Additional cup rack * Bottom spray arm Float ** Bottom basket Dispenser for salt with refill indicator and water hardness range switch 28 29 30 Filters Cutlery basket Dispenser for rinse-aid with refill indicator 31 32 33 Detergent dispenser Catch Rating plate * some models ** The float ensures that the appliance interior is not overfilled. Only customer service may maintain, remove and install the float. You will need to purchase the following before using the dishwasher for the first time: – special salt for use in dishwashers – detergent – rinse-aid Only use products, which are suitable for dishwashers. en Water softener In order to rinse dishes and glasses satisfactorily, the dishwasher requires soft water, i.e. containing little or no lime, otherwise water stains will be left behind on crockery and glasses, etc. If the tap water exceeds a certain level of hardness, it must be softened, i.e. decalcified, so that it can be used in the dishwasher. This is achieved by adding a special salt to the water softener inside the dishwasher. The water softener, that is the required amount of salt, is set up according to how hard the tap water is. Setting up the water softener (see introduction) en Filling the salt dispenser Function of the salt The salt removes the hardness-causing constituents from the tap water. Undo the screw cap on the dispenser 27 . Before switching on the appliance for the first time, pour approx. 1 litre / 13/4 pt of water into the salt dispenser. Add salt until the salt dispenser is full (max. 1.5 kg / 3.3 lb). The water or salt solution is displaced by the salt and overflows. The salt dispenser should always be refilled immediately before washing. This ensures that the overflowing salt solution is immediately washed out and does not remain on the floor of the appliance interior. Then remove salt residue from the filling area and screw down the dispenser without jamming the screw cap. Note If the switch is set to ”0”, it is not necessary to add any salt, as none is consumed while the dishwasher is operating. If the switch is set between ”1” and ”3”, then salt must be ...

Descargar ahora

Introduzca dos números de la imagen: