Votos - 0, Puntuación media: 0
(
)
)
|
Resumen del manual
3in1: They contain detergent, rinse aid and salt function. 2in1: They contain detergent and rinse aid or salt function. >>> Always check the type of detergent or combined product which you are using! Always follow the operating instructions or the information on the packaging. The rinse programme is automatically adjusted in order to obtain the best possible rinsing and drying result. Observe the following important information if using combined cleaning products: Regeneration salt is not required up to a water hardness of 21 dH (37 fH, 26 Clarke, 3.7 mmol/l) only. No other settings on the appliance are required. Salt is still required if the water hardness is above 21 dH (37 fH, 26Clarke, 3.7 mmol/l). Fill the salt dispenser with salt 24 and select setting 6 on the water softening system. If in doubt, please contact the detergent manufacturer, especially if: the utensils are very wet at the end of the programme. limescale forms. en Note Optimum rinsing and drying results can be obtained by using standard detergents in conjunction with separate application of salt and rinse aid. Observance of the operating instructions or information on the packaging of the combined detergents determines their effectiveness. Note Even if the rinse aid and/or salt refill indicator is lit, the rinse programme runs correctly when 3in1 products are used. If the rinse aid refill indicator 5 or salt refill 4 indicator is defective and you would like to switch it off, proceed as follows: Switching the rinse aid refill indicator off and on Hold down the programme button 3 and press the main switch 1 until the digital display lights up, then release the buttons. 8 is indicated on the digital display . Each time the button 3 is pressed, the set value increases by one; when the value is reached, the display jumps back to . To switch off, select the position. Switch off the main switch 1 ; the setting is saved. Switching the salt refill indicator / water softening system off and on Hold down the programme button B and switch on the main switch 1 , then release the buttons. The illuminated button B and the factory-set value on the digital display flash. To change the setting: press the programme button B . Each time the button is pressed, the set value increases by one; when the value is reached, the display jumps back to (the salt refill indicator / water softening system has been switched off). Switch off the main switch 1 . The set value is stored within the device. Approx. 4 litres of water are required to regenerate the water softening system. As a result, the water consumption per rinse cycle increases by 0 to maximum 4 litres depending on the water hardness setting. Note If you use the detergent and rinse aid separately or switch from combined detergents to standard cleaning products, ensure that the rinse aid refill indicator has been switched on and the water softening system has been set to the correct water hardness. en Programme over...
Otros modelos de este manual:Lavavajillas - 3VI951XD/06 (2.3 mb)
Lavavajillas - 3VI951XD/07 (2.3 mb)
Lavavajillas - 3VI951XD/08 (2.3 mb)