There has been a power failure. The appliance door is not shut properly. A delayed start has been set. DRYING knob is in the 0 position. 13 Service Before calling for Assistance: • Check whether you can solve the problem alone (see "Troubleshooting"); • Restart the programme to check whether the problem has been solved; • If this is not the case, contact an authorised Technical Assistance Centre using the telephone number provided on the guarantee certificate. ! Always request the assi

A Cleaning the Sprayer Arms B It may happen that food particle become encrusted on the sprayer arms and block the holes. Check the sprayer arms periodically and clean them when needed. (See close-up view (interior) lett.F-I) Cleaning the Water Inlet Filter Periodically clean the water inlet filter (see figure 2 under "Installation") located on the outlet of the water supply tap. After turning off the water tap, unscrew the end of the water supply hose, remove the filter and clean it carefully un

Arrange the rack with the back wheels in either the top or bottom position and then insert it along the guides until the front wheels are on as well. Close the tabs to lock the rack in place (see Fig. F). Load examples Bottom Rack Top Rack 1 2 3 4Fig. F 5 GB Turning on the Appliance How to start a wash cycle… After performing all the operations described in the previous paragraphs, turn the water tap on completely and press ONOFF button "A": you will hear a short beep and indicator light "B" lig

Error messages. Your dishwasher is equipped with a safety system which is able to detect any operating anomalies. These anomalies are reported by one or two wash cycle indicator lights "G" flashing rapidly. Take a note of which lights are flashing, turn the appliance off and call for technical assistance. Tap off alarm If you have forgotten to turn the water tap on, your appliance will remind you of this by sounding a few short beeps for a few minutes. Turn the tap on and your appliance will sta

To adjust the rack, open up the tabs that lock the guides and pull out the rack. Arrange the rack with the back wheels in either the top or bottom position and then insert it along the guides until the front wheels are on as well. Close the tabs to lock the rack in place (see Fig. F). Fig. A 1 2 3 4Fig. F 5 GB Turning on the Appliance Starting a wash cycle ... After performing all the operations described in the previous paragraphs, turn the water tap on completely and press ONOFF button "A": yo

8.Do not lean or sit on the door when it is open, as this could overturn the dishwasher. 9.If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket. Then, consult the section entitled, "Troubleshooting." If you cannot resolve the problem, contact a service centre. 10.Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. To maintain the EFFICIENCY and SAFETY of this a