Votos - 2, Puntuación media: 3
(
)
)
|
Resumen del manual
From a simple 4-point monitoring system to a complete plant wide hazardous gas monitoring system with hundreds of gas detection points, Sentry meets the need. With the Modbus communications interface Sentry can easily interface with a PC-based Distributed Control System to provide a graphical display of hazardous gas conditions in the plant. PC-based DCS software in conjunction with Sentry provides the operator enhanced data acquisition, alarming and alarm management, historical trending, distributed architecture, and integration into the plant’s distributed control system. Sentry’s Modbus communication interface provides over 620 different parameters accessible by the PC-based DCS software, including: gas concentration alarm setpoints sensor diagnostic messages historical reset time/date power up/down time/date trouble alarm time/date minimum/maximum values plus time/date high/low alarm latch/non-latched auto calibration enabled calibration status/coefficients calibration concentrations calibration due date zone option enabled operate mode Using the optional FieldServer Technologies Gateway the user can convert from the Modbus RTU output to a wide variety of other protocols including DF1, DH+, Profibus, Modbus TCP, ControlLogix and many more. FieldServer Technologies is a division of Sierra Monitor Corporation. More information on FieldServer products can be found at Ordering Information 5387-50 Modbus Communications Interface 4301-10 Converter RS-232/RS-485, 9VDC Sierra Monitor Corp. 1991 Tarob Ct., Milpitas, CA 95035, USA, 408-262-6611, 800-727-4377, FAX: 408-262-9042 Web Site: E-Mail: sales@sierramonitor.com © 2009 by Sierra Monitor Corporation...