Votos - 5, Puntuación media: 3.8
(
)
)
|
Resumen del manual
If all appear to be OK, plug the unit in again. If fog does not come out after holding the remote control button for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue to push the remote control button as this may damage the unit. Contact CHAUVET for servicing. Contact Chauvet USA Tecnical Assistance: 1-800-762-1084 (954) 929-1115 E-Mail tech@chauvetlighting.com Caution • Never remove the Fluid tank from the unit as this will damage the fluid level sensors. • Never use any other type of liquid other than UNSCENTED water based fog fluid. • Use of any other fluids or additives will void the warrantee • Do not obstruct the nozzle. Fog output is very hot, avoid coming within 60cm (24") of the nozzle during operation. Never aim the nozzle directly at people or naked flames. • Danger of Burns. Keep out of reach of children. Do not leave machine unattended. • Output nozzle becomes very hot during operation (300oC). Keep flammable materials at least 50cm (20") away from the nozzle. • Always allow the fogger to cool down before cleaning or servicing. • Never drink fog liquid. If its ingested, call a doctor immediately. If fog fluid comes into contact with skin oreyes, rinse thoroughly with water. • Beware of condensation around the nozzle. Consider carefully when mounting. • All fog machines may splutter small amounts of fog occasionally during operation and for a minute or so after being turned off. • Never place the fog machine on any flammable material (i.e. carpet, fabric etc.) during operation. All fogmachines generate a considerable amount of heat. When placed on the floor, fog machines should always be placed on a non-flammable surface such as concrete or tile. • Depending on the amount of fog generated, all fog machines may set off smoke detectors. Power Connections The unit is supplied with a power plug appropriate to its voltage and destination. Should any other connections be required they must be carried out with the following configuration. Earth = Green/Yellow cable Neutral = Blue cable Live = Brown cable In the USA & Europe, it is required that all plugs are 3-pin type i.e. with Earth/Ground connection. In the UK, it is required that all mains plugs are fitted with 5A fuses. Technical Specifications Power Input: AC 120V 60 Hz or 230V 50 Hz Fog Output: 5000 Cubic Feet per Minute Tank Capacity: 1.0 Liter Dim: 18.1 x 5.2 x 8 in 460 x 132 x 203mm Fuse: Weight: 10A 125V or 5A 250V 7.7 lbs / 3.5 Kg User Informtion (Please complete for your records) Date Purchased: / / Serial No: ________________ Fog Machine F-1050 User Guide Please read these instructions carefully before use World-wide Headquarters: 3000 North 29th Ct. Hollywood, Florida, USA 33020 Tel: +1-954-929-1115 Fax: +1-954-929-5560 Dealer Stamp Model: F-1050 Fog Machine • Fog Fluid Tank On the Rear • Eyebolt for Safety Cable • Remote Control and Cable • Manual Fog Button • Socket for Remote Control • Ready to Fog Lamp • On/Off Switch • Fluid Level Indicator • Power Cord Socket and Fuse holder • Fog Output Nozzle Introduction Congratulations on the purchase of your new CHAUVET fog machine. We are confident you will enjoymany trouble free hours with this unit. To assist with the care and use of the product we have prepared this short guide. Operation Before connecting this unit to the mains power supply for the first time you must first fill the fluid tank withfog fluid and check that the nozzle is clean and unobstructed. This fog machine has been designed to function on a mains power supply of either 120V~60Hz or 230V~50Hz and has been fitted with a suitable power plug for use with your local voltage. Check the label on the unit and the power plug for the correct voltage. Place the machine on a level surface and loosen the cap of the fluid tank to fill with quality unscented water based fog fluid. We recommend use of CHAUVET fog fluid as it has been specially formulated for use with CHAUVET foggers. Plug the remote control unit into the socket at the rear and switch on to allow time to preheat. The remote control will be found at the rear of the unit. Simply remove the two thumb screws andremove from the unit. The cable is stored in the well.Once the machine has reached temperature and is ready to operate the red light on the unit and the remote control will illuminate. Push the button on the unit or the remote control when lit and hold for prolonged bursts of fog. Always monitor fog fluid level as running the machine with no fluid could cause permanent damage. The F-1050 has L.E.D.’s on the front of the unit to monitor the level of fluid. The green L.E.D.’s will light when there is sufficient fluid. The red L.E.D.’s will flash when the fluid needs replenishing. In order to increase the life of the F-1050, the unit will not fog when the red L.E.D.’s are flashing. This feature of Chauvet’s will prote...