Votos - 1, Puntuación media: 3
(
)
)
|
Resumen del manual
Brother advises that this product may not function correctly in a country other than where it was originally purchased, and does not offer any warranty in the event that this product is used on public telecommunication lines in another country. Compilation and Publication Notice Under the supervision of Brother Industries Ltd., this manual has been compiled and published, covering the latest product descriptions and specifications. The contents of this manual and the specifications of this product are subject to change without notice. Brother reserves the right to make changes without notice in the specifications and materials contained herein and shall not be responsible for any damages (including consequential) caused by reliance on the materials presented, including but not limited to typographical and other errors relating to the publication. Safety precautions Safety precautions Please refer to these instructions for later reference and before attempting any maintenance. WARNING There are high voltage electrodes inside the machine. Before you clean the machine or clear a paper jam, make sure you have unplugged the telephone line cord first and the power cord from the AC power socket. Do not handle the plug with wet hands. Doing this might cause an electrical shock. To prevent injuries, be careful not to put your fingers on the area shown in the illustration. Because that part is extremely HOT after you use your machine. iv To prevent injuries, be careful not to put your hands on the edge of the machine under the scanner cover. To prevent injuries, be careful not to put your fingers in the area shown in the illustration. To prevent injuries, be careful not to touch the area shaded in the illustration. To prevent injuries, be careful not to touch the edge of the metallic part shown in the illustration. To prevent injuries, be careful not to put your fingers in the area shown in the illustration. WARNING ¦ When you move the machine, grasp the side handholds as shown above. Do NOT carry the machine by holding it at the bottom. ¦ Use caution when installing or modifying telephone lines. Never touch telephone wires or terminals that are not insulated unless the telephone line has been disconnected at the wall socket. Never install telephone wiring during a lightning storm. Never install a telephone wall socket in a wet location. ¦ This product must be installed near an socket that is easily accessible. In case of emergencies, you must disconnect the power cord from the socket in order to shut off power completely. IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. 2. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning. 3. Do not use the telephone to report a gas leak in the vicinity of the leak. SAVE THESE INSTRUCTIONS Choosing a location Choosing a location Caution ¦ Avoid placing your machine in a high-traffic area. ¦ Avoid placing your machine on the carpet. ¦ Do not place near heaters, air conditioners, water, chemicals, or refrigerators. ¦ Do not expose the machine to direct sunlight, excessive heat, moisture, or dust. ¦ Do not connect your machine to electrical sockets controlled by wall switches or automatic timers. ¦ Disruption of power can wipe out information in the machine’s memory. ¦ Do not connect your machine to electrical sockets on the same circuit as large appliances or other equipment that might disrupt the power supply. ¦ Avoid interference sources, such as speakers or the base units of cordless phones. Quick Reference Guide Sending faxes Automatic Transmission 1 If it is not illuminated in green, press (Fax). 2 Load your document. (See Load documents on page 2-1.) 3 Enter the fax number using Speed-Dial, Search or the dial pad. 4 Press Mono Start or Colour Start. Receiving faxes Select Receive Mode 1 Press Menu/Set, 0, 1. 2 Press or to select Fax Only, Manual, Fax/Telor External TAD, and then press Menu/Set. Storing numbers Storing Speed-Dial numbers 1 Press Menu/Set, 2, 3, 1. 2 Using the dial pad, enter a two-digit Speed-Dial location number, and then press Menu/Set. 3 Enter a number (up to 20 digits), and then press Menu/Set. 4 Enter a name up to 15 characters (or leave it blank), and then press Menu/Set. 5 Press Stop/Exit. Dialling operations Dialling operations 1 If it is not illuminated in green, press (Fax). 2 Load your document. (See Load documents on page 2-1.) 3 Press Search/Speed Dial, press #, and then press the two-digit Speed-Dial number. 4 Press Mono Start or Colour Start. Using Search 1 If it is not illuminated in green, press (Fax). 2 Press Search/Speed Dial, and then enter the fir...
Otros modelos de este manual:Impresoras - MFC-3420C (2.62 mb)