Votos - 3, Puntuación media: 4.7
(
)
)
|
Resumen del manual
FRIGIDAIRE® USA • 250 Bobby Jones Expressway • Martinez, GA 30907 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca MOSS_EW_WD 30INST FR 04/09 © 2009 Electrolux Home Products, Inc. Printed in the U.S.A. 30" Electric Single Wall Oven Specifications • Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. • For detailed electrical requirements, refer to model-specific product page and installation guide on web. • To support Wall Oven when using in combination with Warmer Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base, capable of supporting 200 Lbs. Do NOT use full base, since planks are necessary to allow for proper air displacement. 30" Warmer Drawer Specifications • Voltage Rating – 120V / 450W / 60 Hz / 15 Amps • Connected Load (kW Rating) @ 120 Volts = 0.5 kW (For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.) • Amps @ 120V = 3.8 Amps • Full base of solid plywood or similar material required, capable of supporting 100 Lbs. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. 30" Combination Installation Specifications • Always consult local and national electric codes. (Refer to product-specific electrical specifications on this page.) • Minimum 23-5/8" deep cutout dimension is critical for proper combination installation, to ensure that each built-in product’s faceplate will fit flush against cabinet front. • Bases must be level and cabinet front must be square. • Minimum 4-1/2" required distance from bottom of Warmer Drawer cutout to floor. • Respect critical dimensions as noted for proper installation of built-In products. • Minimum 21" clearance needed for Wall Oven door depth when open. 30" Built-In Microwave Specifications • For built-in installation, microwave MUST be installed with optional 30" Trim Kit which includes Bottom Duct Assembly – shipped in separate box, ordered by individual part number. • Voltage Rating – 120V / 60 Hz / 15 or 20 Amps • Connected Load (kW Rating) @ 120 Volts = 1.7 kW (For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.) • Amps @ 120 Volts = 14.3 Amps • Full base of solid plywood or similar material required, capable of supporting 100 Lbs. • Minimum 2-7/8" clearance required from bottom of Built-In Microwave cutout to top edge of Wall Oven’s faceplate, leaving a 2" visible gap between both product faceplates. 30" Combination Installation Built-In Microwave / Single Wall Oven / Warmer Drawer ...
Otros modelos de este manual:Otros aparatos de cocina - FPWD3085K (614.43 kb)