Votos - 3, Puntuación media: 4.7 ( )

Fabricar: Dacor Tamaño del archivo: 418.87 kb Nombre del archivo: Idioma del manual:

• If the electrical service provided does not meet the product specification, or does not conform to the NEC or local standards, do not proceed with the installation. Call a licensed electrician to correct the electrical service before proceeding. • Be certain to locate the electrical outlet in an accessible location, so that the warming drawer may be easily unplugged in the event that service becomes necessary. Installation Instructions Installation Instructions WARNING • • • To avoid personal injury caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed. Be certain that the power plug is disconnected from the electrical outlet before installation. Verify that the electrical supply matches the ratings found on the appliance data plate and the installation specifications before proceeding. Remove the Drawer Remove the drawer from the appliance to allow access to the mounting holes during installation, and to reduce weight: 1. Pull the drawer out to the fully open position. 2. Push in on the locking tab on one side as you pull the drawer up. 3. When the drawer comes loose from the slide, repeat the same process on the opposite side. 4. Grip the drawer on both sides and pull it free. 5. For safety, push both drawer slides into the drawer opening. StEP 2: Push locking tab StEP 3: Pull up on front of drawer Installing the Chassis 1. Grasp the warming drawer chassis on opposite sides and slide it partially into the cabinet opening. Temporarily support the chassis in place so that it will not tilt or fall. 2. From an adjoining cabinet, reach in behind the drawer and pull the power cord until the plug is next to the electrical outlet. Do not plug in the power cord at this time. 3. After positioning the power cord and plug, slide the chassis completely into the cabinet until the front frame is positioned flush against the cabinet face. 4. Use the screws provided to secure the warming drawer chassis to the cabinet and support platform, insert them into the mounting holes and tighten into place. You may want to drill pilot holes prior to installing the mounting screws. Mounting Hole, 9 Places Continued... Installation Instructions Installation Instructions Re-installing the Drawer 1. Pull the drawer slides all the way out of the drawer opening. 2. Gently lower the drawer between the extended slides until it is suspended by them. 3. Slide the back of the drawer mounting brackets under the drawer mounting clips on the slides. 4. Push one side of the drawer down onto its locking tab, until the tab locks into place. 5. Repeat the same process on the opposite side. 6. Gently open and close the drawer to make sure that it is properly installed. StEP 3: Slide mounting bracket under clip on slide Clip on slide Slide StEP 4: Push front of drawer down until tabs lock into place Verifying the Warming Drawer Operation 1. Connect power plug to the electrical outlet. 2. Operate the warming ...

Descargar ahora

Introduzca dos números de la imagen: