Votos - 0, Puntuación media: 4
(
)
)
|
Resumen del manual
Press a second time to turn off. B. Adjusting Volume Rotate volume knob (1) to increase or decrease volume. Current volume setting is briefly indicated on the display (0 to 31). C. Mute Press mute button (2) once to mute audio output (“Mute” flashes on display). To restore audio output, press mute button a second time, or rotate volume knob. D. Program Selection Press source button (4) to cycle through available program sources as follows: Tuner - CD - Tuner. If a source is unavailable (e.g. no CD inserted), that source will not appear on the display. Page 17 ENGLISH ENGLISH Adjusting Bass Level Press audio button (20) until display reads “BAS.” Rotate volume knob to desired setting. A display of “C 0” indicates center, -2 to -12 indicates bass cut, and +2 to +12 indicates bass boost. Note: unit returns to volume mode if volume control is not rotated for 3 seconds. F. Adjusting Treble Level Press audio button (20) until display reads “TRE.” Rotate volume knob to desired setting. A display of “C O” indicates center, -2 to -12 indicates treble cut, +2 to +12 indicates treble boost. Note: unit returns to volume mode if volume control is not rotated for 3 seconds. G. Adjusting Balance Press the audio button (20) until display indicates “BAL.” Rotate volume knob to desired setting. A display of “C O” indicates center, L1 to 15 indicates left balance, R1 to 15 indicates right balance. Note: unit returns to volume mode if volume control is not rotated for 3 seconds. Optional SunSoundTM Stereo Receiver Radio Operation A. Adjust Fader Press audio button (20) until display reads “FAD.” Rotate volume knob to desired setting. A display of “C O” indicates center, “R” 1 to 15 indicates rear fade, “F” 1 to 15 indicates front fade. Note: unit returns to volume mode if volume control is not rotated for 3 seconds. B. Display Clock Press set button (9) to toggle display between clock and radio modes. When clock mode is selected, the current time displays whenever the unit is left undisturbed. C. Set Clock Press and hold set button (9) for 2 seconds until first time digit flashes on display. Use tune/seek-up button (13) or tune/seen-down button (14) to set hour, noting AM/PM indicator at left. Briefly press set button a second time to select minutes display. Press set button a third time to complete procedure. Unit remains in clock mode and displays time after 3 seconds. Note: When power to spa is shut off for any reason, the clock will be reset to 12:00 AM. Page 18 ENGLISH ENGLISH Open/Close Front Panel Place thumb on front panel release button (7) with forefinger below front overhang. Press firmly on release button, then flip panel open by pulling outward at top edge. To close panel, flip panel up and press firmly until you hear an audible click. Keep the front panel closed at all times to prevent water intrusion, except when changing discs. CAUTION: never insert wet discs into unit or CD player will be damaged! E. Radio Operation Press source button (4) to select radio mode. Station frequency is indicated on display. •To Select Band: press band button (12) to toggle through radio modes as follows: FM1 - FM2 - FM3 - AM1 - AM2 - FM1. Each radio band stores up to 6 independent presets, for a total of 18 FM and 12 AM presets. •To Program Presets: tune in desired radio station, then press and hold desired preset button for at least 2 seconds. PX”, where X=preset number, appears at bottom right of the display. Note: When power to spa is shut off for any reason, all station presets are reset. F. Automatically Setting Station Presets To automatically set station presets to their next higher stations, press the preset button (1 to 6) from which to start programming, then press and hold the auto button (16) for at least 2 seconds. The current station preset and additional preset memories up to P6 will be reprogrammed with their next higher tunable stations. When the auto preset cycle is complete, the unit will remain in preset scan mode and continue scanning for presets until the auto button (16) is pressed. To select only the strongest stations, press the local button (10). All 18 FM and 12 AM presets can be set sequentially by selecting the next band and continuing the operation during auto programming. G. Seek / Manual Tune Press tune/seek-up button (13) once to automatically tune the next higher station. Press tune/seek-down button (14) once to automatically tune the next lower station. To manually tune to a specific station frequency, press and hold either tune/seek button for at least 2 seconds. Holding either button down will increase or decrease the displayed frequency manually. When the desired frequency is reached, release the button. The unit remains in manual tune mode for 3 seconds after either button is released so you can fine tune the station frequency with additional button presses. Note: After 3 seconds, seek mode is re-enabled. Page 19 ENGLISH ENGLISH Scan Functions Select any AM or FM band and press scan button (1...
Otros modelos de este manual:Otros accesorios para la casa - 850 (1.74 mb)