Votos - 3, Puntuación media: 4
(
)
)
|
Resumen del manual
Contact carrier/dealer for further instruction. WARNING • DO NOT install this equipment without first reading and understanding this instruction sheet. If you are unable to understand the warnings, cautions and instructions, contact a healthcare professional, dealer or technical personnel if applicable, before attempting to install this equipment - otherwise, injury or damage may occur. • ALWAYS check the tub bar for proper tightness before using. • Hold the tub bar securely when entering or exiting the bath tub. • DO NOT use the upper gripping position (handle) of the tub bar when lowering or raising yourself into or out of the bathtub. The upper gripping position (handle) is NOT designed to support an individual's total weight. Pushing or pulling the upper gripping position (handle) in a sideways motion will loosen the tub bar from its secured position and may cause injury. • ALWAYS observe the weight limit on the labeling of your product. Check that all labels are present and legible. Replace if necessary. • Apply downward force on the lower gripping position only when lowering or raising yourself into or out of the bathtub. • Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products. • After any adjustments, repair or service and before use, make sure that all attaching component parts are secure. • Bathtub construction varies and this product may not be appropriate for use on all bathtub styles. Bathtubs with sloped inner walls may not provide the tub bar sufficient holding ability. Given this condition the assembly can become dislodged during use. After installation, verify that the device holds as expected. ALWAYS verify that the device is secure prior to use. • DO NOT use this device on bathtubs with lipped walls. • Ensure that inside and outside area of bath tub wall where tub bar will be placed is clean and dry. Otherwise, once installed, the tub bar may not be fully secure to the tub wall and cause injury to the user. • DO NOT overtighten gripping device. Instability to the tub bar and/or bath tub damage can occur. Installing the Tub Bar Lower Gripping 1. Remove the tub bar from the package. 2. Loosen the gripping device. Gripping Device 3. Place the tub bar over the top of the tub wall with the external non.skid pad against the outside of the tub External wall and the internal non.skid pad on the inside of Non-Skid the tub wall. Pad 4. Place the tub bar upright with the cutout portion flat on the top of the tub wall and tighten the gripping device until considerable resistance is felt, but DO NOT overtighten. NOTE: Inspect the tub bar for stability by trying to move it from side to side. 5. If tub bar is unstable, repeat STEPS 2 .4. Using the Tub Bar When entering or exiting the bathtub, hold the tub bar securely by applying force on the lower gripping position. Bathroom Wall Tub Bar Bathtub Tub Wall Internal Non-Skid Pad Cutout NOTE:Model710shown, othermodelshavesimiliarsetup. Position Limited Warranty PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975. This warranty is extended only to the original purchaser/user of our products. This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state. Invacare warrants its product to be free from defects in material and workmanship for three years for the original purchaser. If within such warranty period any such product shall be proven to be defective, such product shall be repaired or replaced, at Invacare’s option. This warranty does not include any labor or shipping charges incurred in replacement part installation or repair of any such product. Invacare’s sole obligation and your exclusive remedy under this warranty shall be limited to such repair and/or replacement. For warranty service, please contact the dealer from whom you purchased your Invacare product. In the event you do not receive satisfactory warranty service, please write directly to Invacare at the address on the back page. Provide dealer’s name, address, model number, date of purchase, indicate nature of the defect and, if the product is serialized, indicate the serial number. Invacare Corporation will use a return authorization. The defective unit or parts must be returned for warranty inspection using the serial number, when applicable, as identification within thirty (30) days of return authorization date. DO NOT return products to our factory without our prior consent. C.O.D. shipments will be refused; please prepay shipping charges. LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE ENCLOSED INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS IF THE S...