Votos - , Puntuación media:
(
)
)
Fabricar: Adaptec
Tamaño del archivo: 634.02 kb
Nombre del archivo:
Idioma del manual:
El documento se está cargando, por favor, espere
 |
El documento se está cargando, por favor, espere
Otros manuales para este modelo:
Resumen del manual
AAA-UDMA Installation and Hardware Guide Note: To load the driver automatically at server bootup, make sure the startup.ncf file includes the load command line for the cdaudmah.ham driver. (If you also have an Adaptec host adapter that uses the Adaptec aic78xx.dsk driver, make sure the driver loads after the cdaudmah.ham driver.) Note: Older versions of the aic78xx.dsk driver (before v1.30) are compatible with cdaudmah.ham as long as the AAA-UDMA PCI slot is not specified on the command line (e.g., load aic7870.dsk slot=z). If there is an AIC-78xx based card (e.g., AHA™-2940) in the system, z must point to that card’s slot number and not to the AAA-UDMA slot number. If loaded without command line parameters, NetWare lists valid slot numbers. The AAA-UDMA will be listed in the parameter list; however, do not select it. NetWare 4.2 and 5.0 Follow these instructions only if you are installing NetWare 4.2 and 5.0 for the first time: 1 Create a DOS partition and install DOS on your hard disk drive. 2 Edit the autoexec.bat file to include a command line for mscdex.exe (the mscdex.exe file is included with MS-DOS 6.x and above). The following sample command lines for the autoexec.bat file are appropriate for most systems: c:\dos\mscdex.exe /M:12 (This assigns the CD-ROM the next available drive letter, typically D if there is only one DOS drive.) 3 Reboot the system to the DOS partition. 4 Insert the NetWare 5.0 CD in your CD-ROM drive. 5 Go to the CD-ROM drive. 6 Type Install and press Enter. Installing the Software Driver for Novell NetWare 7 Follow the procedures in your NetWare documentation for installing a new server. 8 From the Welcome to the NetWare server installation screen, press F2 for Advanced Settings; change Load server at reboot: from Yes to No and continue with the installation. 9 When NetWare detects device drivers for the server, you are prompted to Add, Change, or Delete drivers as needed: – Delete any Multiple Processor Support module that is detected (for example, MPS14). – Delete the Storage Adapters drivers for adapters that are not present in your system. 10 Insert the Adaptec Array1000UDMA Family Manager Set driver disk in your floppy disk drive. 11 Select Storage Adapters and press Enter. 12 To add Storage Adapter driver, press Insert. 13 Press Insert again to add an unlisted driver. 14 Press F3 to specify a different path. Enter the following path: a:\ 15 Select Return to Driver Summary and press Enter. CDAUDMA is listed as your storage adapter. 16 Remove the disk from your floppy disk drive. 17 Select Continue. 18 Follow the procedures in your NetWare documentation to complete the installation. 19 When installation is complete, restart the system. 20 At the DOS prompt (c:\), change to the c:\nwserver directory and enter: server AAA-UDMA Installation and Hardware Guide 21 When the server starts, type down in the NetWare console. Change the autoexec.bat file and t...