Votos - 4, Puntuación media: 3.5 ( )

Fabricar: Panasonic Tamaño del archivo: 1.87 mb Nombre del archivo: Idioma del manual:

Operating Instructions (For Basic Operations) 55 Installation Manual Installation Manual . Hang the elite Panaboard on the stand with the • When installing the elite Panaboard on the screw heads. stand, you can adjust its height to 4 different levels. When changing the height, remove the left and right screws from the back of the elite Panaboard, and securely insert them at the desired height. Torque (greater than 1 N·m [10 kgf·cm (9 lbf·in.)]). 4.Secure the elite Panaboard to the stand frame using the two-wing bolts (M5 . 12 mm [1/2 in.] [2 count]) included with the stand. elite Panaboard Height -100 mm (-3 7/8 in.) Standard +100 mm (+3 7/8 in.) +200 mm (+7 7/8 in.) Screw Position Highest 2nd from top 2nd from bottom Lowest 5. Wipe the screen board surface. Gently wipe the screen board surface with a soft, moist cloth. Note •After installation is complete, use the included cable holder to manage the power cord and USB cable. Notice • Do not use thinner, benzene, or abrasive chemicals to clean. (Doing so can result in discoloration.) • Do not wipe the screen board with a dry cloth. (Doing so can cause static electricity build-up.) 6. Confirm that the elite Panaboard can operate. See "Confirming the elite Panaboard Operation" (page 57). Operating Instructions (For Basic Operations) Installation Manual Installation Manual After assembling the elite Panaboard, confirm that it operates properly by following the procedure below. Action Operation 1 Turn on the power. Green LED lights. Green LED does not light, or red LED is blinking. Confirming the Interactive Features Checkpoints Measure (Normal operation) Check the power cord. See step 1 of "Assembling the elite Panaboard". • For Wall Mounting ® page 52 • For Mounting on a Stand (Sold Separately) ® page 55 1 1. Following the procedure in "Installing the elite Panaboard software" (page 22), install the softwareand, and connect the included USB cable. 2. Confirm that the interactive features are operating correctly. • If a projector is not available, confirm operation using only the elite Panaboard and computer. • When the elite Panaboard software starts, the calibration screen is displayed on the computer screen. • Perform tentative calibration by pressing the 5 points on the elite Panaboard with the electronic pen, as shown in the illustration below. For precise adjustment, it is necessary to use a projector. Approx. 100 mm (3 7/8 in.) Approx. 100 mm (3 7/8 in.) 13452 • With the elite Panaboard software running, enter White Background mode and select the marker tool. Confirm operation by writing on the screen board with the electronic pen and checking that the writing is displayed on the computer's screen. (Your writing with the electronic pen will not appear on the screen board itself.) Operating Instructions (For Basic Operations) 57 Installation Manual Installation Manual To repackage the elite Panaboard, perform steps in "Assembli...

Descargar ahora

Introduzca dos números de la imagen: