Votos - 2, Puntuación media: 4
(
)
)
|
Resumen del manual
The L-CLICK (left click) button on the back of the remote control functions when in [PC Mode] . [PJ Mode] : Functions as a RETURN button. [PC Mode] : Functions as a ESC button. PJ MODE ESC RETURN R-CLICK INPUT SET UP MENU FREEZE ENTER Preparations • The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting. • Do not drop or bang. • Do not leave in hot or humid locations. • Do not get wet or place on top of wet objects. • Do not take apart. • In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation. Note • With the exception of operating a PC with the remote control, all buttons are used in [ PJ Mode]. 18 19 Operating A computer can using the remote control. This function is on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP OS, that is equipped with supporting the USB 1.1 (The supported on OS 9 or OS X for the Macintosh). The operation cannot be guaranteed for all the environments of computers. 1 Connecting a computer Connect the supplied Mouse remote to the computer. Mouse remote control receiver To USB port The remote control may fail to operate if the mouse remote control receiver is exposed to bright sunlight or fluorescent lighting. In such a case, change position or direction of the mouse remote control receiver and retry. 2 Operating a computer The mouse remote control function is available when the remote control is set to [ PC Mode]. (See “ Switching operation modes” . ) Point the Mouse remote control at the mouse remote control receiver, and operate the remote control’s buttons. . Moving the mouse pointer Move the pointer control button in the direction that you wish the mouse pointer to move, then press. . To left click Press the L-CLICK button. . To right click Press the R-CLICK button. . To drag and drop Move the pointer control button in a (L-)clicked state, then when the pointer is over the desired location, release the button. . Using the computer’s up and down arrow key functions Press the and buttons to switch PowerPoint ® slides. Remote Control Front Remote Control Rear ENTER R-CLICK RETURN ESC Pointer control R-CLICK L-CLICK 20 Placement Placement As shown in the figures below, this device can be placed styles. The factory setting is “floor-mounted front projection. ” Set the Projection mode in the default setting menu p.33 , in accordance with your needs. Preparations Projection Distance and Size Use the figures, tables, and formulas below to determine the projection size and projection distance. (Projection sizes are approximate values for full-size picture with no keystone adjustment.) Floor-mounted front projection WARNING • Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus resulting in injury. • If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident. • If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact. Floor-mounted rear projection Ceiling-mounted front projection Ceiling-mounted rear projection Screen As seen from above projection size (inches) – 1.1975 a (min length) = 28.263 projection size (inches) – 1.0446 90° a (max length) = 23.486 As seen from the side Lens center H 90° a a is the distance (m) between the lens and the screen, and corresponds to a range of 1.20 m to 11.00 m. H is the height from the image bottom to the projection size (inches) projection distance a (m) height (H) (cm) min length(zooming max) max length(zooming min) 29.2 — 1.20 5.5 35.1 1.20 1.45 6.6 40 1.37 1.66 7.3 60 2.08 2.51 11.0 80 2.79 3.36 14.6 100 3.50 4.21 18.3 150 5.26 6.34 27.4 200 7.03 8.47 36.6 250 8.80 10.60 45.7 300 10.57 — 54.9 center of the lens. 21 22 23 Operations MONITOR COMPUTER 2 IN (Y/PB/PR ) AUDIO OUT AUDIO IN CONTROL S-VIDEO VIDEO COMPUTER 1 IN (Y/PB/PR ) R L p.43 Before connection • Read the owner’s manual of the device you are connecting to the projector. • Some types of computer cannot be used or connected to this projector. Check for an RGB output terminal, supported signal p.41 , etc. • Turn off the power of both devices before connecting. • The figure below is a sample connection. This does not mean that all of these devices can or must be connected simultaneously. (Dotted lines mean items can be exchanged.) Notes • COMPUTER terminals 1 and 2 function identically. • The AUDIO IN terminal doubles for devices connected to COMPUTER terminals 1 and 2. Connection To audio output To RGB output Contr...
Otros modelos de este manual:Proyectores - TDP-T30U (1.84 mb)